Recent content by 06EC300

Likre the topic says. I am looking for a set of 17inch wheels that will fit an 06 EC300

that is for sure what it looks like to me. OP...get a small flat head screw driver and gently pry the middle part out

7/8" or 1 1/8"?

hey look, another dualsport.ca member over here. Jack is one lucky kid

There should be a power wire supplied with the kit that hooks to the 2 terminal connector...then you run those wires to the battery...or wherever you plan to get power from

I noticed the other night on my 2T 06 EC300 that the vapour gauge back light does not work unless it's hooked to a 12V source

Reserve appears to be about .5L in my tank so that likely would not get me far

DRZ400 dry weight is like 320

Gaerne GX-1

I've got it all sorted out now

I got it to work by wrapping the red wire around the plug wire. now to figure out what the correct idle rpm is to make sure it's accurate.

So you connected the red voyager wire to the spade connector with the yellow wire right at the coil?

I am trying to hook up the tach wire on my vapor gauge....I attached the yellow wire under my seat to the red wire to the gauge and then grounded the black wire to the chassis. When i fire the bike up the gauge seems to work fine at idle but when I rev the bike the gauge goes backwards. I...

like the title says,looking for a 07-10 rear subframe to fit an EC300

I run a dot pirelli trials tire with the tubliss system....love it I've also ran an AC10.....it worked well