Recent content by 2stroker

Thi Guy have some new gas tanks for sale...

v is the fan!

Should be the squish angle adjusted to be parallel to piston dome, to obtain the same measure inside and outside circunference?

Hi gassers I am 40 years old and I started riding a XR250 when I was 18. Then, I rode a XR600, KTM 600, KTM duke (great bike!), and XRV750 Africa twin. Since 98 I entered in quad world with Warrior, Banshee, DS 650 and GG Wild. Good rides.

Is the roller bearing Nj206 ec3? does it still have a polyamide cage? It cracks with age due to gasoline use. Regards

you have to start the engine and let it idle for about 3 minutes. then you check the oil level: it must be in half level reading the lower window, with the engine stoped. It must not reach the upper window with the engine running until 2000rpm. regards

No auto application available, due to the cone shape. If you re-shape the cone housing of your a-arms, you can apply ball joints from a VW Transporter LT. Regards

Hi, I have a ktm oversized radiator fitted, and it really improves cooling. Later I will check it in my quad, and I will let you know details. I am away from home, I will be back next 28 of April. Regards

I have a 300 wild and after a long research and self experiencing I found the perfect formula: 180 main, 38 idle, n1eg on 1st clip from above, and the most important, n? 9 slide! The quad came with n? 7 slide wich is very rich from bottom to 1/4 throttle. I am running at sea level, 10degrees...

Hi hannesd, I borrowed it from a friend of mine and did the necessary machinig on my n?7 slide to equal the n? 9 one. It is an easy job if you get a drill with abrasive sand paper rollers. All you have to do is to cut about 1,2 mm (on slide n?7 profile) to obtain the n?9 intake curve. I will...

the GG Keihin throttle valves have a number stamped on it, and the greater the number the more air flow moves into the carb. So, keeping the same needle and raising the valve number, you get a leaner mixture, especially in low range. Hope it helps. This is a mode we do in europe, I saw it in a...

Hi there, and happy new year gassers! Well, after a long journey testing several sets in my 300 GG quad, I found the perfect formula! pilot 38 main 182 raise the cilynder to clear the ehxaust port set the squish to 1,00 mm remove the 2 washers from the powervalve setup NIEG first clip from...

Nice video. Instead of music, you should put the engine sound, and make it more exciting.

I will try to lock the piston, since the rotor has a round shape. thanks for help.

The camber is the same (angle between floor and wheels). The caster is the angle that influences on rider arms (it is the position of upper ball joint relative to lower ball joint).