Recent content by bally123

Can anyone confirm the depth and width of cylinder o ring grooves? Need accurate measurements as want to use o rings to convert a non o ring engine. Cheers andy

Trying to identify my friction plates, 2.9mm thick and bonded on aluminium backplates. Any ideas who makes them? Are they gas gas or maybe cr250 spec? Cheers andy

Hi Looking at fitting a V force 4 reed block to my bike. I currently have a boysen assembly. I see on gas gas parts diagram for later bikes that there is a rubber gasket between inlet pipe and reed block, does this come with reed block or do in need to purchase separately? [/IMG] Is there...

So I am having a few issues where the clutch grabs, kinda groans (not squeals). Its intermittent but occurring more regularly. I pulled the clutch tonight and the outer basket looks worn - grooves in the fingers. Inner looks pretty good. However I am confused about the plates,the frictions...

Cheers for reply..... Sent from my GT-I9300 using Tapatalk

I'm around 200 lb kitted up. I will double check preload. Its definitely not a comfortable ride and sits really high so something is off. Thanks for the reply. I'll post back with findings...... Sent from my GT-I9300 using Tapatalk

Anyone know the length center to center of a standard dog-bone suspension link? 2005 EC 250, Ohlins shock Cheers Andy

So my 2005 EC has allways sat pretty high, compared to other bikes. Allthought this suits my 6'3" frame it also makes the bike really agile, bit too much in high speed sections. I checked the rear spring and its an ohlins: 00596 10/52 L344 I think 344 is the length, is this a standard spring...

So an update: The bike is way better than its ever been, power is smoother and gas usage is now similar to other bikes. idle was ok but then as the day warmed up it began to stall, I didn't adjust air screw and I 'm sure that would have helped. Still have further to go to improve things but its...

Well in desperation after a long standing issue with idle problems & slow speed loading up I added a notch. So far I have the best idle I ever had. So 2005 Ec 250, modded head and squish set. DDK needle, # 8 slide (was a 7 that I cut on a milling m/c) 42 pilot and 175 main Now here's the...

Hi Trying to resolve running issues so I'm looking for a #8 throttle slide or a complete PWK 38. Anyone got one lying around?

HI Guys, Float height is correct, even adjusting it too be low makes no difference. Crank is new with new seals, leak down tested fine. Top end is new Reeds are original Gas Gas, they have not been replaced but look mint and seal tight, no gaps, chipping or signs of wear. Currently got a DDK...

Guys Having refreshed my motor I have again tried and failed to get the carb set up to idle properly. Bottom line is the idle mixture screw is simply not effective. Having carefully set the slide so it is not bottomed out on the idle screw I have tried a range of jets from 38 - 45. The mixture...

Thanks for the confirmation.

Will 2007 plastics fit a 2005 bike? Been offered a full set for OK money. Cheers Andy.