Recent content by bergerhag

The fastening bolt for the clutch lever and hot start lever can lock up the hot start if over tightened. The cut out issue - fuel starvation maybe? Check fuel tank vent hose, fuel flow from fuel tap. What is your idle speed set at? Small displacements four strokes normally likes idle speed set...

Unfortunately I did not get to test it under proper conditions, just scooting about on a parking lot.. But what I can say is this: With me at 97 kg without gear and I still did not get a lot of sag(could barely reach the ground) it seems to sprung on the heavier side. Adding gear to it would...

It is very tall. I just barely got my toes down on both sides, and I am 180 cm , but with legs on the shorter side (30" inseam on jeans). For me it felt right at home both standing up and sitting down. I don't ride many KTM's, so I cannot adress that reference

I got the opprtunity at my dealer to swing a leg over a brand new threehunner. Importer was out on a roadtrip to excite and engage the dealers, with a preproduction EC as the bait. Oh my.. Unfortunately it was my lunch break, wearing office clothes, so it was very brief spin on the parking lot...

Currently eight of them. With the release of the 2018 it might be nine... 1992 GT 32 2000 TXT 280 2005 EC 450 FSE 2006 MC 65 2010 EC 300 2011 EC 125 2012 EC 300 2014 EC 250 F Nordic. This is my current bike

Pressurized cooling system with bike cold means something else is getting in there. Does it smell of exhaust down the radiator fill hole? Cracked head or orings gone bad?

It might be related to the scorpion selector with its spring. Look at the bottom left in the picture n this thread http://www.gasgasrider.org/forum/showthread.php?t=15613

friend of mine mounted kibblewhite black diamond valves for DRZ into his 2004 450. Slipped right in

Good to know. I was thinking of going that way, but it was cheaper to uninstall it :)

I have raced mine (2014) hard for two years now, sporting a Rekluse Exp 3.0. It is however not easy on fuel doing this, a full tank of 8 l keeps me going for 2 hours. I have for this season opted for removing the Reklse and moved back to std clutch, to be able to pull it a bit lower down the...

Marzocchi moto department was saved by italian company VRM http://www.visordown.com/motorcycle-news--general-news/marzocchi-bought-by-italian-engineering-firm/30641.html

I have used a lower shock bearing from my 2014 Sachs in my STX46 Ohlins. The inner diamater is not the same, but if I used the spacers from the Sachs unit too, all was fine.

It is a zener diode voltage regulator. It cuts off the tops of the positive ac phase and almost all of the negative. Basically it shorts excess voltage to ground. The input resistance would be the coil itself in bike applicaton.

As far as I understand, there will only be trials bikes for 2016. The enduros needed more work and will be redesigned, and produced earliest 2017

according to the GG workers Facebook page the deal is now closed A google translate of the spanish text looks a bit better