Recent content by Cball917

Have been out of town. Just got back a few days ago. FWIW 98-02 YZ125 parts all interchange. Fired her off tonight. Rebuilt the top end including power valves and springs!

Aluminum. Using The yz cross reference i will have a a new top end, power valves with new springs and gaskets for around $200

They fit like a glove

How about these?

That sounds promising! I am not sure what you mean by non-tm though. Do i just mic the shaft to find out size?

Hey guys I haven?t been on in a while being wide open coaching ball. I am hoping you guys can help me out. Last weekend we went on a pretty good ride. Bike ran great until we were almost back to truck. Kinda choked out and went to crank and had very little compression. Figured I may have broke a...

Cheapest i found was eBay $92 shipped

Had a hard time finding a bash plate that was listed for my 2002 125 xc. I ordered a moose 750 plate listed for the 98-04 200/250/300 with the thought i could modify it . All i had to do was drill a 3/4” hole for drain plug and trim out a 1”x 3” section to give more toe room on shifter. As far...

Have a 02 xc 125. Looking for a skid plate. I have found some listed for a xc/ec 200/250/300 but not many for the 125. Whats difference in frame sizes

Do you still have anything off it?

i have found a few , but they list them fitting a 200 and up. is there a lot of difference in the frame in a 125 vs a 200? or if i find one that fits a 200 will it fit my 125?

I am afraid that I am going to have to bite the bullet and do this

Thank you sir. Was hoping for a used one

Wanting a skid plate for gg125 xc 2002

No it’s the 10 bolts for the triple clamp. I have 8 good ones , one that’s stripped and one that’s broke. Nothing locally has anything close. I can find them in PA , but $5 and some change is pretty expensive for me .