Recent content by CDBiker220

Im near Pittsburgh. I have a 180 main and 45 pilot but that's because I have a N3CH needle that leans the bike out and needs bigger jets. When I had the stock needle I tried the 2nd clip position to lean it out. It was still a bit rich even with the 175 main jet. I would try going up one clip...

Just wanted to give some feedback on this. My 2018 EC300 ran pretty good but had some nagging issues, had to jet it pretty rich to get rid of the occasional possibility of it running a bit hot and pinging when really beating on it, also a lot of spooge from muffler. Decided to try the RK Tek...

Thanks for the tips, the magnet is present in the rotor, I had already checked for that. I will do a couple tests, double check the connection at the computer and if needed replace the sensor at the wheel. I'll follow up with what I find. Thanks.

Hey before I dig into this just thought I'd see if anyone else had this happen. My enduro computer is not registering any speed when I'm moving, just says 0mph, this obviously affects trip and overall milage. Hour meter still working. Everything looks good as far as the wire to the sensor and...

On my 07 GasGas it had one of those instead of a thermostat (#16). On my 2012 the thermostat deformed and I could not clamp a hose to it so I replaced it with one of those.

Thank you, manual/parts diagram are not clear on this.

(2012 Ec300) There is a bushing on the the right side of the crankshaft the seal rides on. It has a beveled edge on the O.D. of one side. Does anyone know if the beveled side faces inward or outward?

The 2012+ generation is taller than the 2011 and prior bikes. They needed to be, I'm only 5'8" and my 2007 was too short, foot pegs too low. Not sure the 2012 seat height is much higher but they are now up to modern standards. That said I've owned a 07 EC300, now own a 12 EC300 and test rode...

I rode a 2018 GasGas EC300 and the 2018 Four stroke FE and FX. I already knew I love the GasGas 300 motor but the KYB suspension is just perfect combined with the lower weight compared to the 2017. The FX husky was way too harsh and the FE was too soft. The KYB suspension on the GasGas was...

Watch the first 30 seconds, RV behind the GasGas https://www.facebook.com/racerxonline/videos/10150909625444955/

Watch the first 30 seconds, RV riding behind the GasGas https://www.facebook.com/racerxonline/videos/10150909625444955/

So they had 2 stroke parade laps before the start of the official races at the high point national and there was a 2018 GasGas 300 out there. It was pretty cool to see it rip around a moto track with Ryan Villopoto on a KX250 along with a ton of other great riders.

I'm planning to service my shock myself soon. 2012 EC300 with the Ohlins 888 shock. I plan to at least replace the seal head, not sure what else yet (anything I should just buy in advance?). But I'm wondering where everyone that does their own work buys Ohlins parts? Thanks. - Chris

I just found the same problem. No supersprox, orderd an Ironman and then found out it was on backorder. Ended up getting a JT front sprocket from the local dealer.

I ended up sending mine to FCR suspension in Ohio because they are a Ohlins dealer and the shock needed rebuilt anyways. They replaced the bearing at that time. I tried to get one from gofasters and ended up getting a older style needle bearing. I would go on ohilins website and look up the...