Recent content by cladoo

Will a S3 head from a 2010 fit a 2019? 300EC

I ordered some parts for CPD on Jan 29. Just the new bendix cover and a couple gaskets. About $50 USD. Now I live in Alberta,Canada and CPD wanted $99USD about $135CDN to ship it to my address! I have a Montana PO box through a company called DYK post that will pick up my parcel in Montana and...

Yea I never liked the gold frame colour. So I painted it red.

It's definitley a Nambotin. It was mine that I put an estart on!

I just finished this 1975 YZ250B!

My 2019 XC300!

I got most of it from a donor bike and then bought the rest of the parts. Not sure what the overall cost was. I don't think the parts are available anymore.

So this is just a bolt on replacement part? Part #?

Go for it!

I have one from a 2010 but it has a crack in it. I'll try to get a pic of it.

I took out the thermostat also as I needed room for the switch manifold and the temperature sensor on my Voyager.

So I never did get the thermo switch from the guy I bought the fan kit from. So I ordered one off of fleabay and installed it. The spec for this switch is supposed to be 85c(185f) on but it turns on at around 75c(167f) and doesn't shut off until around 60c(140f)! The switch that was supposed to...

I am asuming that the water pump impeller on a 2019 300XC is plastic. I'm just wondering if I should order an aluminum one as last year my 2010 Nambotin melted its impeller.

Yes it is! Shipping would be about $85.

I had the same thing on my 2010 Nambotin. It was the centre case gasket at the top where the intake is. It only sucked tranny oil when I was on the gas!