Recent content by coble

Hey guys! I had my 2018 ec 300 rebuilt and ever since then my tranny oil gets black extremely quik. It seems to me it leaks down from the power valve rod in to the clutch side and Dirty?s the oil. Are there not any seals on the power valve to keep it from doing this? Thanks Steve

I was having a similar issue and realized that the seal should drive in to the stopping point and not riding on the groove and the gear collar. Seems to be fine now. You might consider that when installing. I included a photo to show how mine is installed.

Hey fellow Gassers! I have a 2018 EC 300. I dropped the bike about a year ago and the clutch master cylinder has been leaking. Rebuilt it and it is still leaking. Couldnt find a scratch, crack or nick in the bore so I?m not sure what?s happening. I would like to replace it. Does anyone know...

Hey all! I have a question for some of the wizards out there. I?m trying to pull the bearing/gear that?s pressed in the side case in the starter hole of a 2018 gas gas ec300 out to remove the idler shaft. Does anyone have an idea how to remove these? Added a photo below. Thanks you I actually...

Any updates on this thread?

I have read everything I can find and ordered 3 different needles to try. Thanks

I have a 2018 ec 300 with 37 hours on it. The bike smokes a lot and splooges like crazy. Currently have the stock needle on the top clip with a 38 pilot and 173 main. Plug is black and crusty after a few rides. Averaging 40-50 degrees Fahrenheit 7-800 feet in elevation. Anyone else had this issue?