Recent content by craigyboy

I have. I will go through them and re list this week .What are you after? Also are you in uk?

As title.See parts for sale section.

Hi I have some parts for sale in uk. Trusty adjustable power valve. ?180 Biketech large volume power valve cover ?40 2010 plastic sump guard new. ?20 FMF Powercore silencer 03-06 ?50 FMF Stealth silencer 07- ?80 Flywheel weight ?40 Marzocchi fork springs 4.8 ?40 GPR Steering damper with...

Hi I have a 2006 ec 300. The problem is when lights are on they flicker . Not brighter as it is revved but bright and dim from tick-over all the way up. Any ideas. It is a bit like a dodgy connection ,but I have checked and cleaned everything I can see. Help I'm going mad.

Thanks a lot Thanks, found allens performance.Sorted.

HI, Does anyone know where I can get a cck needle in the U.K

I think its a 300 sherco with Graham Jarvis onboard

I had similar problems and tried lots of different things, pv rebuild etc. only to discover after lots of grief that it was the new air filter I had installed.It turned out that it didnt allow enough air through . Just a thought!

yeah takes about 10-15 mins for a rear tyre ,a bit longer for a front as they are a bit more awkward with lots of knob faces. but still a lot better than changing tyres all the time and also no accidental punctures or scuffed knuckles from the sprocket.I have also noticed that better quality...

Just shipped a knobbyknife to uk. Total cost with import duty came to £65. I thought it was a little expensive for what it looked like,untill I used it .What a great tool! I have re-trimmed the tyres on my sons bike ,my bike and also six rear tyres and three fronts .All of which would have been...

yes no worries, fits straight on . I use this setup on my 06 300 from time to time .

I had the pivot pegs and loved them, untill I snapped them off whilst jumping a double jump.(not good!) I then lost confidence in them and got fastways no problems with these yet. But I do miss the pivoting action.

Happy Christmas ! To everyone on the forum.

I had a problem on my 06 ec300 and wondered if anyone else had similar problems.The circlip holding the primary gear iii & iv climbed out of its groove whilst under hard acceleration allowing the gear to move on the shaft. this caused it to mis mesh with secondary gears iii and iv causing a...

powerpegz I had a pair of powerpegs. When I first had them I was very impressed I liked the movement over whoops etc. What I was'nt impressed with was the way that they sheared off whilst landing from an 80' double. Thankfully I survived . I now have a set of fastway pegs as I have zero...