Gummed up with a dab of what? You said in a earlier post that your piston was mashed as if it was stepped on. You surfaced the piston totally flat correct?
When installing the stack it is good practice to shoot breakclean between shims and piston then follow with compressed air with the nut...
FMF Gnarly Pipe for all 250/300 from 07 to 11 Part # 117-025095.
Has not been mounted since its return from pipe repair shop.
The finish is dull and there is slight surface rust but it is straight and mounts good. Asking $125 and 10 to ship
2011 GAS GAS 300 6days - A nagging wrist injury forces sale.
Bike is like new! It has very low hours on it. I have revalved the suspension for East Coast single track. Currently is sprung for a 180-190 lbs rider. RB designs and head & carb mods already done. Also have stock springs to go with...
Anyone think there is a possibility this spudder is ignition related? (bad mapping in the blackbox) Mine is much worse in rain mode. I desparately seek an answer. I cant drop the main jet any smaller as my bike acts lean after extended wot.