Recent content by exman

Could you please give me a clue, I'd like put one on mine 2012 EC300. Btw, my KTM 525 would appreciate it too. Tks

I wonder if it was necessary to make two cuts, it seems that the one on bigger diameter is sufficent to pull the cat out.

After I saw review on ENDURO CROSS TRAINING, I've decided to adapt the OEM pegs to move them down and to the rear. Just cut off pipelike extension on peg and have it TIG welded on the other side. Switched the springs position (left goes on RS and right goes on LS) and did some grinding of...

Are those seals the same for 2012 EC 300? It is not specified in GasGas Parts List.

Well, here is what I have found in my Keihin PWK38 AS: pilot #45, main #170, needle NOZI (position 3rd from top), throttle valve slide no6, mix screw 1 turn out. As I said, no experience with 2T, I own and ride KTM 525 exc. My impression is that Gasser pulls well but I really haven't had a...

Hi John R B, unfortunately, there is no Parts warehouse in AZ or Parts guy in PA..actually there is no supplier at all in my country and that's why I am forced to bother you guys more than usual.

EC 300 2012 Vforce3 reeds Mr Jakobi you were right about the Part number. I have attached the picture but there isn't much to see, I have found only traces of some grey sealant on both sides of reed cage and no gaskets. It seems I'm gonna make two gaskets as a first aid and try to find genuine...

Bought Gasser a month ago and I'm trying to get familiar with 2T technology:D. Having problems with idle, I have pulled out carb and reed cage..There should be one crankcase gasket and one rubber gasket according to the parts list but I haven't found any!? I could try to make it myself since I...

Have taken carb off: it is clean but bowl gasket is broken and I'm waiting for a replacement. Float level is ok, pilot #45, main #170, needle is NOZI (never heard) 3rd noch and throttle valve #6. Any suggestion for the altitude around 1000 feet?

When started, it keeps rpms higher than normal for idle. Than I put it in gear, and release the clutch slowly with the brake on. Rpms drop to normal and stays low (I switch to neutral). Than I open the throttle for a sec and idle remains high again. The mixture screw is one turn out. I don't...

All I have to do is to choose among the solutions:).Thanks a lot guys!

I'm in desperate need to renew bearing and seals on the rear wheel and replace badly worn spacers, but all I can find on Ebay are for 2018-2019. Does anybody know if they suits 2012 model?

Hi there, I've seen somewhere your generous offer for Gasser EC300 Workshop Manual..and would be happy to get it if your offer is still valid. Mine is 2012, have never owned 2T before, so you can imagine all those hesitations. Any advice would be welcome too. Hope this won't bother you too...