Recent content by fatdaddy

  1. F

    08 gasgas ec300 in KY ***SOLD***

    how do i upload a pic
  2. F

    08 gasgas ec300 in KY ***SOLD***

    ill get some pics up later in the week. I work away from home so it will be fri. or so. Thanks
  3. F

    08 gasgas ec300 in KY ***SOLD***

    Also would be open to trades on other bikes.
  4. F

    08 gasgas ec300 in KY ***SOLD***

    New jug and piston, kickstarter shaft, YZ kickstarter, Brakes, longer gasgas shifter with hammer head end, new reeds, wheel bearings and Chain and sprockets. All other bearings checked and greased. Have new rear fender, airbox covers and shrouds still in the plastic. I also have a bunch of other...
  5. F

    Would you buy another Gas Gas?

    mine is an 08 ec 300 and I know it has been raced sence 08 it was a kinda a dealer demo the dealers brother raced it for two years and then when he went to a four wheeler the owner just rode it for a while then it was sold to the guy I got it from who didnt ride it much he said Im dont think...
  6. F

    Would you buy another Gas Gas?

    no not a dealer the guy bought it from a dealer and he had it on here as a low hour dealer bike. The reason I bought it was i knew the dealer and had seen this bike when new at the races and figured that it had been took care of. The guy I got it from only had it a short time. it ran good but it...
  7. F

    Would you buy another Gas Gas?

    Thats just what i found in the last couple of days I have went through the motor all bearings done a yz kickstarter conversion with new shaft,the reeds are 01 cr 250 i called v force to conferm so i got them for $50 but its still just sucks gettin parts for i needed some parts to race this...
  8. F

    Would you buy another Gas Gas?

    I dont think so at this point I have had my 08 ec 300 since nov and all i have done is work on it. dont know if it was just abused or if its a gasgas thing the bike does handle well but the forks suck. thought it was about ready to ride floats stuck forks leak reeds chipped and so on if I would...
  9. F

    08 ec 300 vibration

    does the 300 normaly have alot of vibration mine seems to.
  10. F

    freshin up ec 300

    I just traded for a 08 ec 300 that needs some work I am going to put a new top end on it I seen the cylinder is marked A but I dont have it took apart yet. Will it be a safe bet to go ahead with the A piston or should I wait untill i get it apart and do some mesuring. Also may have the squish...
  11. F

    kick starter help

    yea my buddie is a mill wright so we are going to make a spacer and also take the slack out of my brake by installing a bushing. One of my friends owns a moto recycling place and has a 250f kick starter on his yz 2T and he has a bunch of the 250fs but they have the same machined area on them. so...
  12. F

    kick starter help

    got a 07 yz kickstarter and when i put it on my 07 ec300 it slides back and forth on the shaft. the splines dont go all the way through like on the GG one so the bolt just tightens up on the shaft but the starter will slide back and forth. Any of you all run into this
Back
Top