Recent content by GavGav

  1. G

    ECU mounting

    There is already a strip of rubber on the frame here. Seems to work OK. I always felt like there was a bit of a strain on the cables when I removed the tank.
  2. G

    ECU mounting

    Anyone else tried this? After having my bike serviced at a non GasGas dealer the bike came back with a cable tie around the ECU holding the multipin connector in place. I was told it the locking tab had broke when they tried to remove it. :mad: The only way to "fix" it was to buy an new...
  3. G

    Cam chain Slap - FSE 400

    I am going to ask a silly one... but thought I should... You sure it is the cam chain and not just the drive chain? Mine gets noisy when loose... I even have it a little tight just to stop the noise.
  4. G

    Blue/Yellow wire disconnect, must you now retrim??

    Thanks Tony, I saw your post without the answer. From what you say about worse fuel economy and from JDRoz comment (Thanks JDRoz) I think I will leave it disconnected. The real question is: do I now need it re-trimmed ?:confused: :confused: It was last trimmed with the wire connected.
  5. G

    Blue/Yellow wire disconnect, must you now retrim??

    Hey...yo... I have found a bike shop that is closer than the 2 hour drive one way to my "local" GasGas dealer/expert. They do a lot of EFI and DUCATI stuff. I wanted them to trim the EFI as I think it was running a bit rich. I also had the weeping cylinder gasket done there as well. I am...
  6. G

    Cylinder gasket leaking.

    Hi all the GG crew... Anyone ever had a cylinder gasket leak coolant? :( It weeps out with high revs... Checked the bolts and they are up tight. If the Cylinder gasket has to be replaced do they also have to do the head gasket in the process? I only had the head gasket done less than...
  7. G

    Acewell Speedo / Tacho

    I think i better check the output voltage ASAP!
  8. G

    Acewell Speedo / Tacho

    Mine just went last weekend. About 80 hours. Have not had a look yet why...... Just starting the process. It is totally blank... Bugger!
  9. G

    Roll call

    Sometimes....
  10. G

    Radiator / head gasket blown?

    Bump Anyone got any ideas? Anyone?
  11. G

    K Scan and how to connect it?

    Do you have a link? I could not see anything on the http://www.gasgasmotos.es/eng/frame.htm site :confused:
  12. G

    Radiator / head gasket blown?

    Hey all, hope someone can put my mind to rest. My 07 FSR has a habit of loosing coolant. I suspect it is the head gasket. Symptoms: Looses fluid. (200mm aprox per ride) System stays presurised for a few days, even when cooled down to stone cold. The fluid in reservoir behind the head-stem...
  13. G

    Kick Start 07 FSR 450?

    Good on ya! Dead flat battery?? Did you have to give it a few kicks to get some power into the fuel pump for it to build up some pressure?
  14. G

    FSE450 overheating question

    James, I had the oil light problem like you.. It was fixed on warrenty. Something about the clutch cover?? Mine also overheats on tight single track and slow muddy uphill climbs. PM JRDoz he has added a 06 fan to his 07 if I remember right. I will eventually get around to it. Gav.
  15. G

    Kick Start 07 FSR 450?

    Thanks tokadin! When the bike was warm I tried your technique it and it works a treat:D Then this morning. Stone cold I did it first go! You just have to listen for the strange sound... Cheers again mate!
Back
Top