Recent content by Gerardo

Btw, your comment was: Not sure if it will help but try safety wiring the throttle cable where it enters the carb. The GasGas cable is different than other bikes the way the cable end is made. On mine I could not get the idle set consistently and this was the problem. What do you mean with...

Hi Jeff, I just found your comment from 2011 about a inconsistent idling on a GG. Can you help me with your experience? I ride a EC300 2011 Nambotin, with a APT Smart Carb. Idle is inconsistent and I have always to play around with the idle screw (it depends if in gear, holding the clutch...

Hi BSM2, may I please ask you a few questions? I?m installing a EE855002513 kit, but on my 2011 EC300. Perhaps you can help me with the following: - Is there no Relays/Solenoid holder in the kit? Not included. Should I hold it only with a Zip-Tie? - I'm stuck with the electrical wiring...

Hi pscook, may I please ask you a few questions? I?m installing a EE855002513 kit, but on my 2011 EC300. Perhaps you can help me with the following: - Is there no Relays/Solenoid holder in the kit? Not included. Should I hold it only with a Zip-Tie? - I'm stuck with the electrical wiring...

Hi rosco, may I please ask you a few questions? I?m installing a EE855002513 kit, but on my 2011 EC300. Perhaps you can help me with the following: - Is there no Relays/Solenoid holder in the kit? Not included. Should I hold it only with a Zip-Tie? - I'm stuck with the electrical wiring...

Hi Bob, greetings from southern Chile. Can I ask you a few questions about installing/setting up a new e-Starter Kit, which is just on its way from the US to Chile. I normally am extremely meticulous while working on my GG EC300 2011 Replica Nambotin. It is a fantastic bike, I do everything by...

Hi Bob, greetings from southern Chile. Can I ask you a few questions about installing/setting up a new e-Starter Kit, which is just on its way from the US to Chile. I normally are extremely meticulous while working on my GG EC300 2011 Replica Nambotin. It is a fantastic bike, I do everything by...

Hi Claude, tnx for the info. Is your starter running fine? I've read about plenty of issues with the bendix and/or the adjustment (clearance) between it and the FW gear. Do you have any installation suggestions or are there any somewhere? Have you done the CH80 Honda bendix mod? Is it worth...

Hi Claude, tnx for your reply. Where is the 2012 CDI positioned, do you have any picture or is it shown up in a 12 Manual? I also figure out to enlarge each single wire that goes to the CDI, no problem to me to do that, but perhaps I need to remove my CDI to make place for the battery. What is...

Hi Claude, tnx for your reply. Where is the 2012 CDI positioned, do you have any picture or is it shown up in a 12 Manual? I also figure out to enlarge each single wire that goes to the CDI, no problem to me to do that, but perhaps I need to remove my CDI to make place for the battery. What is...

Hi, while I'm waiting for my E-Starter Kit (EE855002513), which is on its way from the US, I have a question: The E-Starter Kit (EE855002513) is for the Gas Gas EC300 2012-2013. Their CDI is positioned differently than it is in my EC300 2011. I don't know if I can reposition my CDI for the...