Recent content by Grav

AMS oil I was running AMS Dominator at 50:1 in my EC300, and it always ran srong and clean. On the recommendation of some very knowledgable mechanics, I tried AMS Saber at 100:1, and the bike ran rough (sputtered) under load at mid-range. It appeared to be running a bit rich. I switched back...

Anyone know the crossover (equivelant) Excel rim and spokes for an 06 EC300? Suppliers do not list Gas Gas parts.

My bike is an 06 EC300. My pictures are too large to post here, but if you send me your email address, I will forward the photos. Tom Gravenish tgravenish@cogeco.ca

Just installed a Hyde skid plate that I bought from Gofasters. Although there were no installation istructions, it was relatively easy. I first removed the exhaust pipe. I then positioned the skid plate and put the bike on a stand to hold the plate in place. The treaded rod works well to...

Doesn't look good.

Nambotin and Redmond riding the extreme section - Day 2 - Round 3 http://youtube.com/watch?v=3iHycINFn1g

Thanks for the post. See you in Parry Sound this weekend. Hope the Gassers fair better in Canada. Tom

I went to the Motosprotz site and GG's were not listed. Is the site out of date?

Tom G - Ontario - spectator, probably only the 2nd day.

I am also running the 13/50 setup on my EC300 and find it perfect for the woods. Run a lot of 2nd and 3rd gear, as well as some 4th - only use 1st in the tightest situations, but it comes in handy when needed. Often start in 2nd. Agree with the previous post re the bike becoming a wheelie...

I have an 06 EC300 which I am very happy with. I have not yet had to do any major engine work (only jetting changes). I will probably replace the piston next winter (it will have 2 seasons on it). I am looking for advice on what parts to use. Is an original Gas Gas piston recommended, or...

I rode Bultaco trials bikes (Sherpa 350) back in the late 70's when they were winning all the world championships. Stopped riding about 1980 and didn't ride for about 25 years - family, work - you know the routine. My sons got me back into riding a couple of years ago. When I started again I...