Hellcat's latest activity

I was thinking close valve rev it till it chokes then open valve a little see if it changes it's tune and I have new nylock nut and...

It might but you would have to rev the engine and open power valve at same time and not positive if you can time it all correct . But...

What did your figure out.

On another note . I’m a Kawasaki Kdx which had similar ignition system the stator tested fine . But aftering changing cdi with new and...

Yes it has big flywheel and washer for timing

On my previous question asking if it was ec or xc . The ec has the large flywheel / stator setup that uses the special shaped washer...

Unhook the linkage rod and see if the lever opens all way . Believe there is an Allen bolt in there that acts as a lever stop ?

Usually issues like this is caused by someone who did something wrong previously and your trying to hunt down what it is .

Another thought . Does power valve fully open ? Wonder if guy installed power valve upside down ? Not sure if you physically can but...

Like I said friend bought a 2002 years ago and it did and sounded exactly same as yours . His stud on the power valve bracket was broke...

Get a new Teflon locking nut also . There is a washer that is special also . Prevents binding

Did you buy this bike running like it is now ? Have you tried a new / different spark plug

You might be able to flip the reeds over . I don’t think the reeds are going to be the issue when it goes to rev up though and cuts...

Also might want to pull silencer off And see if its Clogged . Run it without and see if runs better . Could be something in expansion...

Those reeds are not shutting . This will give poor performance down low . I would upgrade to v force reed assy . You will have to cut...