Recent content by Ignas

  1. I

    Center case seal

    I have assembled two bikes without center gasket, just regular sealant. One has 80h other 60h without any leaks after rebuild. My friend assembled with center gasket and water leaks through it
  2. I

    Machining Stock Clamps for KYB forks

    I have machined one with 3 years trouble free trail riding
  3. I

    450 fse 2004 help no start

    My fuel pump is still producing 3bar pressure at all times but my strainer is damaged and lets all the dirt through fuel pump ant injector. I need the part that is near fuel pump in this picture. Did you used old gasgas strainer or adapted new one?
  4. I

    450 fse 2004 help no start

    I had similar problem, wouldnt work below 2000 rpm. Just backfired and stalled. Turned out to be clogged injector. And the reason is that early models fuel pump strainer is rubbing into fuel tank and then allowing all the dirt to pass. Anyone now where to buy only the strainer? Gas gas sells...
  5. I

    FSE 450 pick-up coil data

    I have bought new one for 15 euros from alfa romeo 146 if i remember correctly
  6. I

    Cylinder o ring groove depth

    I have bought these size orings for my ec300 out 107.67x1.78 Int 75.92x1.7
  7. I

    FSE engine wanted in UK or near it (complete, damaged or parts for it)

    I have: Old style engine (starter in front) with damaged starter gears and flywheel Newer style (starter in back) with cracked casings Cant make one working engine so will buy complete working engine or damaged. Willing to buy parts that i need if someone have them. Prefer UK but can arrange...
  8. I

    Cheap tatty/cracked plastics up to '12 wanted in UK or europe

    I have sent pm
  9. I

    Cheap tatty/cracked plastics up to '12 wanted in UK or europe

    Anyone got badly worn plastics and want to get rid of them cheaply? Will take any plastics from '98 to '11
  10. I

    Flywheel Weight 2007 300 EC

    I have made this one too, one on ec300 '07 and other on ec250 '02. Works great and weights about 650g
  11. I

    Large fuel tank for two stroke 00-12 in Europe

    Anyone??
  12. I

    Top end rebuild

    Best bet is youtube and workshop manual. Dont forget to measure ring end gap as you can damage piston and cylinder.
  13. I

    Bore Diameter Check

    You have to measure cylinder for wear and pick the right piston. If you dont want to measure and you are sure that its 135 hours just put the same size piston. Better buy forged piston but remember that you need more piston to cylinder clearance than cast. Also check your rings end gap before...
  14. I

    Rear Brake rotors and rims

    Dont know if they changed something in wheels but rear rotor is the same as ktm
  15. I

    What fork springs are you guys using for your specific weight?

    Think it might be because of closed cartridge forks. Or you like high jumps more than me. I have almost 0 sag at front when on bike
See more
Back
Top