Recent content by jmdcr50

I took the v force reeds from my yz 250 and put them in my ec 250

I second that with Dave

Go to auto parts store.

If you are using v force reeds I checked with the 08 yz 250 I have and fit in my 08 ec 250

Nice vid . Nothing like living near the mountain's you get to see the views that a lot of people would never see

Fly wheel pullers are cheap , I had bought one for a cr 250 and it fits yamaha and gasgas .Also if you have a harmonic balancer puller all you have to do is get longer bolts it works very good . when your ready to put the motor back together stack bearings on the flywheel crank side and slowly...

Just so you all know My v force reeds were shot on my 08 ec .I also have an 08 yz 250 and the v force fit on the ec also

07 and up have one piece rear fender and side plates

okay link dosen't work . go to dirt bike magazine and ckeck it out

http://dirtbikemagazine.com/wp-content/uploads/2015/05/used2strokes.jpg I don't post here very often but I found this and thought I should share. I hope the link works

Ya the taillight is led so just a matter of fixing up the wires and I should be good to go

So I was messing around on my bike I think I found the problem .I disconnected the wires going to the taillight and the headlight worked .I found all three wires a the taillight connection were cracked and probably touching. I love wiring

Thanks Neil will check it out this evening

The switch is brand new, It's the same result with old and new switch.. I have 3 bulbs that I have been testing with unless they are all burnt.

If anybody could give me a hint would be much appreciated , I have power to my headlight switch ( all I have is a test light ) when I turn the headlight switch on the power pretty much disappears ( very faint light on the the tester) could this be a ground issue . Thanks in advance