Recent content by jyellard

Pictures Send me a text if you want more pictures. Thanks, Josh

Pictures Pictures

SOLD - 2007 EC300 - plated in SW Indiana SOLD - 2007 GasGas EC300. Cylinder was just replated, rehoned, and a new piston installed. Titled, registered, and plated as a street legal motorcycle in Indiana. I have the lights, turn signals, etc for it to be ridden on the street. Top end was...

Ec300 It didn?t sit too long. I used some contact cleaner to clean the connections to the ?electrical box? under the seat.

Piston I?d like to think I wouldn?t have done something that boneheaded but maybe I did! Can you tell from this picture?

I am the original owner of a 2007 EC300. This has always been an extremely reliable bike. Never even fouled a plug. I just installed a new piston, gaskets, and reeds. I heat cycled it after it was rebuilt, and no hint of an issue. Then the first time I went to ride it, after a few minutes...

Thanks Neil!

Another question So the electronic flasher module will work with the dirty AC coming from the stator with no rectifier? Will it work with DC from a battery? On the flasher module, the 3 prints are labeled L, M, and C. Which is power (yellow), ground (black), and common turn (orange). Thanks...

After attempting to read the factory wiring diagram I've determined my bike isn't wired per the diagram. So I figured I would find which wire is hot and make my own to be able to install a dual sport kit. I have the 2k-2 ignition, wires leave at 10:00. I have a plug under the bars that would...

I am guessing the US bikes have a different main wiring harness than the Euro bikes. I believe the 2 wire plug at my bars is for the headlight, no high beam just running light, and the 3 wire plug under my seat is tail light/brake light? No idea what the 2 single wire plugs are at my bars

2007 EC300 dual sport wiring help I have a 2007 EC 300 that I bought new. I bought (hopefully) everything I need to make it street legal from motocrosscenter a couple years ago and now I'm trying to install it and need some help. I have the front light, bar mount controller, all turn signals...

I did the same thing I did the same thing on my bike with less than 20 hours on it. Never again will I drill out a plug with out left hand drill bits. You will have to split the cases. Mine was stuck to a gear due to the magnet. ENJOY!

The e-mailing back and forth and the wait caused by time zone differences are what took the longest for me to buy from them, but I didn't have many troubles due to the language barrier. However, you will EASILY recover the shipping costs thru the reduced prices. Also, paypal makes the currency...

Thanks Cberg! Those pictures were very helpful. The fitment isn't perfect, but won't keep me from buying the Clark. I assume the Clark has brass inserts for the shroud screws? I think this will be a huge improvement over the stock plastic inserts that have pulled out on me a few times. As...

After a wreck at Loretta Lynn's Spring Ride my gas tank started leaking fuel. I have read about a lot of issues fitting the Clark tank. Some have been using heat guns to change the shape of the tank so that the radiator shrouds can be properly secured. Have these been resolved? How...