Recent content by Kpo73188

Thank you

07 300 2 stroke. Looking to sell or trade for a 450r or trx250r atv. Engine has about 8 hrs on it. Crank was rebuilt by ken oconnor with a new pro x connecting rod. Top end was replaced with a s3 vertex piston kit. Water pump rebuilt with a new billet high flow impeller. Every bearing and seal...

I changed the oil with amsoil 10 40, and it did not change the noise at all. Any other ideas of what it could be?

I've been running type f atf, I'll try a different fluid tomorrow and see if it helps.

Hi I have a 07 ec250, over the winter I did a complete rebuild of the engine, every bearing and seal was replaced, crank was rebuilt and the top end was replaced. I just recently got around to breaking the engine in, at first it ran great then it began loading up, long story short, I knicked the...

1998 ec250 6 days bike, engine and kickstand are already gone, everything else is available. Will sell everything for 400, located in Maryland

Hi I'm looking for an expansion pipe and possibly a silencer for my 07 ec250. Looking for an aftermarket pipe, thanks

Hi I just picked up a 2007 ec250, I noticed a rattle when the rpms are coming down. I read about adjusting the powervalve. when I pulled the pipe off the bike I noticed the powervalve was covered in carbon and I'm able to wiggle the valve back and forth in the cylinder, about an 1/8in either...

Hi, I'm looking for a set of front fenders for a 300 wild hp, I'm also looking for a set of the narrower a-arms. Thanks