Recent content by kyton

I see these tyres are also greatly priced. Will definitely look at a set of them when I am able to get my next scoot. :)

Aren't you going to try the Batt tyres out?

Calender sounds cool Found this link for Save GasGas. http://salvemosagasgas.webnode.es/

check my gasser out. You see that. so much heartache. :(

I googled the part numbers and one of the sites came up with the ref size as well.

the stock orings stock are 101,32x1,78 and 72,7x1,7 ones i can get are 101.34x1.78 and 72.76x 1.78 will these be fine

Anyone know what the 04 200EC compression should be. Want to check mine before i swap out the piston & rings.

Mine idles now with new settings. Seems to be a little rich still. find the bike very easy to kick & you can push the kick lever from top to stop position by hand going to do a compression test and in the process of getting another piston and rings. Must also replace the idle screw as the...

I have the only adjusted with idle screw. The nut on the top of the carb is all the way down now. Needle that was in there was a nbwh. Don't know I I put a 172 main in if it will make a difference or move the clip from 2nd to 3rd Mine is a 04 200ec

I have idle screw all the way in now. Put a 38 pilot in. Idles now when warm. Feels like it bogs a tad from 1/4 to 1/2 throttle and then lets rip. N1ec needle 2nd clip. 175 main. Sealevel

How does 1 set the 1mm gap. With idle screw or the nut on top of carb to pull slide up.

I have put the 38 pilot in. Only way i can get my bike to idle from start is to raise the throttle slide by using the nut on the top of the carb.

Im getting a 38 pilot. Going down from a 42. Going to see if it helps mi idle. How would one check for an airleak?

Think you got more chances of getting ambushed by illegal miners.:D

Nice Stuff :) :)