Recent content by lindsey97

i removed the kicker from my 4 stroke 2005 wr250 yamaha and it fit perfectly on my 04 gasgas ec300. so i ordered a used one from adrenaline cycles in corbin kentcky.

what happens when more than one bike wont start??

i use a Raytek Minitemp laser temp gun. have several of these for our dump trucks, bulldozer, or other equipment. very handy to have in your trail tool bag, just point at the top of your cylinder head or the radiator top and it gives you a temp reading in F or C. not bad for $49 at the NAPA...

please tell us the proper tool to heat the airboot with. brand would be great. i have an oxy act. torch but im guessing this will be a tad too much.

i agree with the previous post. i carry a IR scan laser gun with me at all times to check my engines temps on my bikes and 140-160 deg. F is all i ever see. this is on my banshee, 02 rm125, 04 ec300 gasgas and the the wr250f. if a bike gets over 200 deg F then you have problems, or will have...

bowhunter: i just bought one of those plug wrenches on ebay. if it doesnt fit then i will grind it to fit. jakobi, i sent my head and carb to RB Designs. hopefully my squish was high and it was effecting my jetting. i feel i was very close on jetting with the 38 pilot, CEK needle, and 180...

so i just need to spend the $20 on JD software kit? i appreciate your advice and i realized the needles were all different types of taper. i figured the spark plug wrench was a gasgas one, could someone post a picture of one? i bought the bike used so im learning. i will make one if...

hello all, just aquired a 2004 gasgas ec300. going over the bike, fixing little things, greasing everything, and have been playing with the jetting. my elevation is 850ft. and the temp is 40-72f right now. i am using yamalube mixed 32:1 with 91 octane premium. weather is warm one day and cold...