Recent content by macho comacho

  1. M

    Standard Jetting

    Hi Could somebody tell me the factory jetting settings for a uk 2004 ec300. Many thanks macho.
  2. M

    down hill

    Hi Guys Not sure where to post this so here go's. When going down a steep hill my bike will stall unless i blip the throttle, is this to do with a float problem or do all 2 strokes have this problem. 2004 ec300 Cheers Macho
  3. M

    jetting

    Hi all Thanks for all the replies and ideas, just one question is the CEK needle richer or leaner than a CCK ? Cheers macho
  4. M

    jetting

    Ok cheers iancp5 yes its a 300 and i use the bike for trail riding so i will stick with the jetting i have until it warms up.
  5. M

    jetting

    As i'm in the uk the rbd mod is out.The slide is a 7*.would a 38 pilot be too lean.
  6. M

    jetting

    Hi all I have been trying to get rid of a sputter at small openings on the throttle and have tried 45 and 42 pilots,but with these pilots the air screw had no effect either in or out.Then i tried a 40 pilot and the air screw now worked but only at 3.5 turns out. My jetting is 178 main,40...
  7. M

    Pilot

    I'am at sea level and have tried the air screw all the in and all the way out,looks like i'll be ordering a 45 and 48 pilot. Thanks for the quick reply...Macho
  8. M

    Pilot

    Hi all I seem to be having problems with my idle as in i cannot get one,the air screw has no effect and when all the way in the bike will stall. Have checked for air leaks and the jetting is:- 2004 ec300 Pilot *42 main *178 Needle cck 3rd clip There is snow on the ground at the moment so quite...
  9. M

    Carb icing

    Thankyou for a quick reply, I will try the suggestions and let you know how i get on. Cheers Macho
  10. M

    Carb icing

    Hi all, I was out for a ride last week and the temp was about -1 the bike seemed to be spluttering on any throttle so i checked the carb and there was ice on the slide and down inside the carb,Has anyone had this problem and how can i prevent this from happening and dont say not to ride when...
  11. M

    gasser 250 sm spluttering and fouling plugs

    Plug Hi I know its not very clever but i just installed the plug and went riding, the bike didnt foul the plug all day.The BR8 plugs have a resistor the b8 do not so i belive run hotter,If you have any more problems phone dave @ biketech(01225765765). Cheers macho
  12. M

    gasser 250 sm spluttering and fouling plugs

    Plug Hi Have you tried a B8eg they seem to work on my bike. Cheers Macho
Back
Top