Recent content by malcolml10

Well got the NEDH and installed clip position #2 still won't idle but seems to run a little better. Ain't got much left to play with to try and make it idle, guess I need to sell it and but something that will actually idle for at least 30 seconds at least

thanks, will try that trick next time carb is out. Have ordered an NEDH needle will be here next month so will see if that makes a difference

Looks like the current needle is an NBHW from what I can make out. The clip is currently at #2 position from the top.It also seems to be a bit bent, like someone has forced it off or on previously, so should probably replace at the same time. The slide has a 5 stamped on it, I guess that's the...

thanks I'll try and have another look at the needle thats in it and see which one it is. Parts are not that easy to come by in NZ sometimes.

Ok i have tried my hardest to sort this out but i cannot solve. My 04 EC200 has been running rich and won't idle. Hers the setup as I know it: Main jet 175 Pilot Jet 40 (was 52) Needle clip position 2 (Don't know type of needle, can't read whats stamped on it) Float set at 16mm corresponding...

there are lots of posts in this forum about PV rattle. I have started to hear a loud rattle on my 04 EC200 but at the same time i've also noticed my bike is running really (really) rich whereas before it wasn't. I'm not sure the 2 things are connected but they both seemed to start at the same...

thats what i thought, but there seem 2 different types available and the 04 model seems to be the straight through type. Someone mentioned taking the pipe of and bending it but it would need to come about 30mm down and thats going to compromise the upper mount

(Reposting this in the correct forum) Noticed a vibration on my EC200 and it appears the lower exhaust pipe mount has sheared off. I can't understand how it works as there is no way I could force the pipe mount bracket to line up with the frame bracket as per photos. Am I missing something...