Recent content by maneuon

I believe that jd needles do not work with Brazilian fuel 27% alcohol. I'm using the blue needle #5 with pilot 42, and the bike sounds lean at high revs with low loads, when I release the throttle with the power valve open, and when I'm on the highway with high speed and I accelerate and...

The bike is only lean at high revs (open powervalve) but with low accelerations (1/8)

The bike is lean only when I'm on the road at high revs and only 1/8 of the throttle. It also happens when I'm accelerating everything and I release the accelerator, it gives a lean symptom when the accelerator is 1/8

Goodnight I live in Brazil and our gasoline has 27% alcohol My Gasgas is 300 2011 I'm using 40 1 and 1/4 in air #4jd red and 180 The bike runs well, I just think it smokes a little at idle. When I go at 1/8 it goes well until the power valve opens and it goes lean. What should I test?

I was 130mm now I'm down to 140mm I'll try. The spring preload has not yet been adjusted, it is original My compression pants are 22,19,17,15(0.1) it never reaches the end of the course, it's missing about 2cm. I'm going to walk and see if with the lower oil it works better in the course

I'm thinking of installing the race tech gold valves and seeing if the suspension works acceptably, otherwise I think the solution will be to change them. I looked at a 47mm show on ebay and the value is attractive. I think even the original ones would work better, then later I change the...

the spring that comes on the suspension is 0.42 and the ideal spring for my weight is 0.40, it's not that far away. like i said even motocross bikes with heavier springs are better than mine. Assuming that my spring is for 75 kg and the suspension is good for 75 kg, it would suit me too, it...

Is it possible to get a good adjustment on this suspension? I'm disappointed. she's new and I don't like her. even motocross bikes with suspension for heavier riders are better than my bike on the trail

Boa noite amigo, tem o contato do seu WhatsApp? Queria conversar melhor com voc

I just wanted my forks to work well, it doesn't have to be a specific setup for me. But they are very bad on the roads

I live in Brazil, it is not possible to contact this company

I rode the bike today after putting the 7.5w oil at 130mm. I was happy with how it handled the big obstacles, but the road rib vibrations were too aggressive in my hands.

Can you tell me what was done to yours? I would like to copy to mine

I understand perfectly, but I'm not willing to spend a lot on these forks, so I think it's more feasible to buy another one that's more up-to-date. I just wish they would stop hitting my hands so much, even on small irregularities.

Goodnight I have a 2011 gasgas 300 with marzocchi shiver forks I've messed with them a lot, but whenever I ride the bike they make my hands sore I tweaked the valves, softened the compression, stiffened the rebound, I'm using 7.5w oil and things have improved, but I'm still not liking the forks...