Recent content by maxfli11

My bad. Price now showing. Thanks

(SOLD) Very nice GG EC300. Needs absolutely nothing. Race or ride ready. Comes with a lot of spare parts. Got maybe 25 hours on complete refresh, top and bottom. Suspension serviced 3 hours ago. Lots of spare parts including a complete set of OEM plastics still in box. Located in west TN...

My needle shows to be a N1EF. I've yet to find that needle marking on any Keihin site. Stock needle shows to be 48-DDJ. Stock jets should have been 55/170 Is the N1EF some after market needle? i don't find the needles NECW, or NEDJ you recommended either. I'm missing something somewhere. I'm...

Ideling Ok so I got the same issue. Bought a 2005 G EC300. Can't make it idle for the life of me. Finally bit the bullet and opened up the carb. I'm running an N1EF needle on the last notch. A 35 main and a 170 idle at around 500 ft, above sea level. From What I've read here that seems very...

Anyone changed their 45mm Shivers, to Showa, or KYB? What did it take to accomplish the feat? I've got a 2005 EC300.

You'll note that link only references the 2010-2011 forks.

2 hours away. Sorry haven't checked in in a while. I'm about ready to sell it. It is very frustrating to find parts for this thing. I'm trying to get heavier fork springs for it now. I might as well be hunting Unicorns. Stupid how GG just stops supporting stuff over three years old.

Thanks Frankenburg! good place to start. It is the round top Air Stryker. Gonna take it apart this week to see whats actually in it. Will update then.

Hi all. Is there anyone here that has, or does ride in higher elevations? planning to take my 2005 EC300 to Colorado this July. We'll be riding some pretty thin air. I'd say at least 7-8 thousand feet. Won't take it to the higher passes most likely. Save that for the XR650L, but 13000 ft max if...

The 2018, possibly other models also had main bearings that have plastic cages. They do fail in the 100 hour range consistently. Don't know why GG would do this other than to save a dollar. They were going through a financial crunch around that time. I've got a friend with one that just got his...

Oh plug is dark and wet by the way.

Is there a carburetor tuning procedure here somewhere? I'm running 50:1 Amsoil with non ethanol pump gas. Guy I bought it off of said it was jetted for pump gas, I failed to ask what oil he used. It runs well mid and full on, but smokes quite a bit and soots up the fender. Won't hardly idle...

It's not there anymore I bought it late Jan.

Which model is compatible with a 2005 EC300? I've read conflicting reports. One says the 202-101 is the one to use, and another says 202-111. Don't want to got through the hassle of sending back a wrong one if I can help it. Thanks

Anyone tell me where i can find the side stand and applicable mounting hardware? Previous owner removed it all and I'd like to replace it. Why are the older bikes so hard to find parts for??