Recent content by moto520

Bought new in December 07 right out of the crate . modified with following entire 99 KTM 380 mxc front end with 50 mm wp conventional forks summers fork brace . KTM front wheel KTM 2.50 x 18 rear wheel KTM brembo front and rear brakes complete KTM hydraulic clutch master and KTM front...

Im comparing the shock on the gasser to my tried and true 525 KTM which I mainly ride motocross on but occasionally ride woods. The Gasser shock on the mc 250 gets real stiff at the last 3/4 of the stroke compared to the more Linear KTM shock . Im running the 99 KTM 380 sx front end which is a...

springs Ive been setting up a new 03 250 mc and it came with a 5.6 spring I got a 5.2 which tested at 5.4 and I have a 5.0 that tested to 5.2 I ride A and weigh 215 and this bike is strictly set up for offroad . I went to a 4.8 yamaha spring on the Olins shock so I have these springs...

shock and springs Well I decided to send the Ohlins shock to Mike Wiesner because it just wasnt working right . The 5.0 spring tested out to be a 5.2 and the shock had alot of trapped air so it wasnt bled correctly from the factory. There was alo a rebound check valve installed from the...

Anyone have a set of .40 springs for a set of 50 mm wp extreme forks conventional?

springs DLS, Got the springs check is in the mail thanks, Went with the 5.0 . the 5.4 was still too stiff for offroad . I actually want to try a softer spring yet. The gasser must have an aggressive ratio . My KTM 525 still is better with a greater range of adjustability with an exc shock...

Ok will sell the 5.6 make an offer

I used the brembo because I had a spare complete set up from a Katoom plus changing pads is much faster . I didnt want to change the nissan in case I want to put a stock Gasser wheel on again when I sell the bike.The brembo also has a more progressive feel where as the nissan is grabby .

DLS email me your shipping address and I will send you the money or paypal if you want. My email is performance@csinet.net Thanks Darren

Email me a price on that 5.2 performance@csinet.net

Thanks for understanding Go fasters has been very helpfull

I need a longer shifter badly Where can I get a hammehead shifter for an 03 mc250?

Its very easy to convert to KTM rear wheels . I just did it but used a KTM Brembo caliper, mounting bracket and hose with a little modification it went right on

Im just passing this along. I have several sets of KTM wheels and wanted to run the rears on the new 03 mc250 I took a spare KTM brembo caliper and mounting bracket with KTM brake hose . The Hose fits right on the master cylinder of the Gasser. I milled 2 mm off the outboard side of the...

Dave3283 Man sorry bout this but Go fasters is going to trade my messico for a new Gnarly . I spoke to them after I posted this .