Recent content by Moto7man

  1. M

    Rieju ranger 200 from Italy

    It’s Kayaba which is the best. Set your preload and sag then fine tune it as it breaks in. I run 111mm.
  2. M

    Rieju ranger 200 from Italy

    Yes, I have a Ranger 300 and I like it a lot.
  3. M

    Enduro Engineerng Skid Plate Model 7018 fits 2018-2022 GasGas EC 300 and Ranger

    Enduro Engineerng Skid Plate Model 7018 fits 2018-2022 GasGas EC 300 and Ranger $100.00 Includes mounts.
  4. M

    Ohlins shock rebuild shop?

    Call Drew Smith at Works Enduro Rider he knows the ohlins forks and shocks thoroughly. When your components come back you just bolt them on, set sag and you are ready to ride. He is super savy on the ohlins stuff. https://werproducts.net/ Email: werproducts@gmail.com Phone: (908) 637-6385 Fax...
  5. M

    Is a full rebuild worth it for a 2008 GasGas EC300? (Cylinder + Piston)

    I still have my 2011 EC 300 and it runs and looks great. I can ride it as fast as my 2022 Ranger 300. There are some things about my 2011 that I like better than the 2022. If you sell or part out your 2008 you probably will never find another one. These older gassers seem to be great bikes. I...
  6. M

    Throttle sticking/binding

    Sorry for the delay on an update,I haven’t been riding since this modifcation. This week I pulled the Ranger out to prep it for a ride and this longest cr throttle cable (as listed above) is too short. The slide is about 10mm from bottoming out. So,I guess I will call motion pro and have them...
  7. M

    2025-2026 MSXC Race Schedule Tennessee Kentucky

    https://www.midsouthxc.com/home
  8. M

    Parts for 2011 gas gas ec 300

    I think you have to rotate the starter housing 180 degrees to correct that. Someone probably took it apart and then reassembled it incorrectly.
  9. M

    GasGasec300 factory replica 30th anniversary

    My bad,I thought they kept the plastic subframe until they stopped production of that frame and jumped to the 2018 frame.
  10. M

    A new problem with starter

    I just had mine laser welded and it already had the wet mod from the factory. It also had the bearing in case for the starter shaft. It works like a champ.
  11. M

    GasGasec300 factory replica 30th anniversary

    Nope, it was 2012 to 2017. The 2010 and 2011 were the B frames with an aluminum subframe. Then in 2012 they scraped the B frame for a perimeter frame( like a kx frame) but it was heavy so they used the plastic subframe to save weight. I have a 2011 EC 300 with the B frame and aluminum subframe...
  12. M

    My Front Axle just broke | 2018 GP 300

    Does anyone know if the axle recall applies to the Rangers?
  13. M

    GasGasec300 factory replica 30th anniversary

    Yes, eBay is a disaster. I would never release a bike without the cash in my hand.
Back
Top