Recent content by motopsycho87

  1. M

    e10 fuel and squish?

    I run 1mm squish but with the ebowl opened up for approx 13:1 static compression. E10 works fine
  2. M

    What oil do you use?

    https://www.smithandallan.com/product/smith-allan-limitless-ultra-4t-15w-50-fully-synthetic-motorcycle-oil-4119
  3. M

    2006 Shock Rose Joint P/N or dimensions

    Found it OHLINS REAR SHOCK BEARING - LARGE 14X26X15 Bearing dimensions: Outer Diameter 26mm Inner Diameter 14mm Inner width 15mm Outer width 12.75mm Also Fits the 1999 Beta Techno, the Beta Rev 80, Beta Evo80 and the Beta Rev 3 from 2000 to 2008 with the Paioli rear shock...
  4. M

    2006 Shock Rose Joint P/N or dimensions

    This on the top shock mount of 2006 ohlins. I've taken it out, ID 14 OD 26 Width1 12.75 Width2 15 Found nothing yet...
  5. M

    2006 Shock Rose Joint P/N or dimensions

    Does anyone know the specs of the above? I have a lot of play in mine and it wants replacing :)
  6. M

    Help! Stumped?? Kickstart jam 98 ec250

    I've had the same before, with mine it was the little nylon spacer for the spring had indexed round so the cutout wasn't mating with the spring
  7. M

    Crank seal leak?

    Remember it's not just the crank seal, behind the primary drove gear there is a collar on the crankshaft, behind that collar is also an o ring that can fail
  8. M

    Ignitech cdi

    Images attached
  9. M

    Ignitech cdi

    I've had an ignitech on mine for years now, it most certainly is plug and play. If you message them they will put the correct connectors on. I run a pretty aggressive map that works well and compensates well for the 1.5mm base gasket I've got. I love it. And yes, run a resistor plug and cap and...
  10. M

    Fmf gnarly figment for the 2001 ec250

    You can order whatever front pipe you want, only difference is the front bracket is either offset or not. I have the pre-2009 silencer on my 2011 update, i had to space out the front most mount with washers, otherwise not a problem.
  11. M

    Fmf gnarly figment for the 2001 ec250

    I put a gnarly on my 2006/2011 on Saturday, fits better than the original. Only difference between models is the front exhaust mount anyway. Later end cans fit different though but will fit on either spanny.
  12. M

    What did you do to your Gas Gas today?

    Last night's jobs were; Fit 5.7N/mm rear spring and set sag Fit new S3 power valve assembly Fit new FMF gnarly front pipe
  13. M

    Ngkb8es plug

    There is no benefit in running a non resistor plug. The resistance protects from back emf which can potentially cause damage to cdi
  14. M

    Mobile phone App for enduro riders...

    Couldn't as free more !!!
Back
Top