Recent content by MuddyArgyle

Walker county Georgia, just south of Chattanooga.

Hi all, I have a 2011 ec300. At one point I was using it for pretty gnarly hard Enduro type stuff. As of the last top end, I tuned it accordingly (base gasket/exhaust port height). Since then I decided e start would be really nice for hard Enduro so I bought a newer Beta. Great bike but I...

Apparently we're almost neighbors as I live just south of the tn/ga border. Anyways, I have an 11 ec300 that came to me with a rekluse auto. I tried a lot of things to get it to feel the way I wanted. In the end I ended up buying a rekluse manual pressure plate that was compatible with the...

Bummer they have a WP logo on them. Seems kind of out of place. I wonder if they are customizable to the point of removing that? It says custom number/name so that makes me think there's a chance. I do like the look of those graphics though.

Bummer they have a WP logo on them. Seems kind of out of place. I wonder if they are customizable to the point of removing that? It says custom number/name so that makes me think there's a chance. I do like the look of those graphics though.

So what all swaps over from the 200 to 250/300? I take it the frames and mounting points are compatible. Exhaust? Electronics?

Not Today, but a few days ago. I live sort of on the edge of a rural area and the suburbs. I rode my (non plated) ec300 down the road for a few miles, mostly on the shoulder so as to not cause too much trouble. At one point I came upon an area where the ground had been built up to allow the...

Looking for some info on forks. It looks like 200ish up to 08 had marzocchi 45mm USD forks. At that point did the standard models switch over to Sachs 48mm? The 2011 EC300 six days also had 45mm marzocchis. Are these the same as the earlier models? I'm trying to find some seals etc. for my 11...

The company that made the bike in 2005 is like 2 or 3 times removed from the gasgas of today. KTM gasgas has 0 interest in old Torrot gasgas, or the previous independent (I think) gasgas. You might try searching by the actual suspension manufacturer.

Do you have the suspension rocker arms? Part number BE250314007

Thanks for the advice everyone. I installed the seal having the same way as the old one was. I did install the o ring, but not until after I put in the main seal (I didn't realize that's where it went). I pulled the collar out and then put the oring in, then put it all back together. I will...

2011 ec300. I have been trying to figure out why my bike is running rich (super smoky, some bogging, lots of oil out the pipe). I have replaced the reeds, piston has maybe 20 hours of mostly low revs, and I replaced the crank seals on both sides. It's still smoky, and on my last ride the clutch...

I had been trying to figure out why my gasser (11 ec300 six days) sounded like it was falling apart, and rode without the 'scorpion racing' aluminum skid plate that was on it when I bought it. Ahhh, nice and quiet, but unprotected! So I set out looking for products or solutions to dampen the...

Ok, so I think I have solved things, and figured it would be good internet etiquette to respond to all this here in case someone else has a similar issue and finds this thread via google or something. I took the slave off again, and yes the shaft was free to move inside. I think the issue was...

Also potentially interested... is bike still available?