Recent content by mxdad316

I'll be there buddy, lookin' forward to it. I'll catch up with you when we get there.

I can't believe you are selling that bike Alan, you're gonna miss it!

Hey Buddy this Wayne you used to race with. I have a 200 engine from a 99 I have been saving to put in a 125 KX frame, it may or may not fit yours. We can take some measurements. I would part with it if you can use it. This engine had a scored cylinder & I bought another one on ebay that has...

Thanks for the offer Gasser, I will keep that in mind. It will be after Christmas before I can spend any more on bikes. Motoman 7 did the 87 Cr's have a front disc brake?

Thanks for the offer ADV rider. That's a good price but I'm really looking for some "right side up" forks that came on a woods bike, I think those usd CR motocross forks will be similar to what I have now. I'm trying to avoid revalving if I can. If what I have read is true KDX forks are simple...

Ok, I have a 2001 xc300 with the wp 43mm forks. My forks have some pitting in the chrome & one bottom bolt is stripped. I want something different rather than spend a lot of money on the wp's. I have thought about the Yamaha SSS conversion, but It seems really expensive. Even if I did that I...

http://bham.craigslist.org/mcy/4174124212.html I have a lot of good used parts with the bike, & some 200 parts & plastics too. I would like to sell everything together if possible.

I have his kit on my 2001 & love it. If it's the same kit he sold me it has bushings that replace the needle bearings & cages. You re-use the metal sleeve that the bearing normally rides on. It has all lnkage, swingarm, & lower shock bushings along with new o-rings. So far I have three rides &...

I'll buy the whole rear brake caliper with the bracket if that's easier.

I need a brake caliper bracket, mine has worn so bad where the pads slide in that they just flop. If anybody has one they will part with for a decent price let me know. Thanks

I see your bike had black shrouds & you are changing over to red. Would you sell your black shrouds?

I ended up buying 2 magicshine 808 led lights & put one on the bars with the 30? lense and the other on my helmet. I just used them last night for a couple of hours and I love them. They are amazing for such a small light. A guy on my 24 hr team bought a cyclopse led adventure light for twice as...

Will do Glenn, I'll post the results. Thanks

Yes, I have the old screw cap as-1. I read several long posts about needles & idle, seemed like the #8 slide worked for some. I had a spare 7 & thought they could be made leaner with a little filing. The notch is actually on the engine side of the slide, I was not sure if it had the same effect...

Hey guys, 01 300 XC, CCK needle middle clip, 40 pilot, 172 main. The air screw has to be 3 turns out to be clean. I'm in Alabama the home of high humidity, it's between 70-80 degrees now & about 500-1000ft. elevation. I like this setup, but I have to raise the idle more than I like, I think I'm...