Recent content by NerdFrog

I got two rainy rides out of my Magicshine before it shorted out. I sent it back for an exchange or refund and never heard from them again. My friend fared better and has about 20 rides on his now. It's still a far cry from the Trailtech HID setup! The best I've found though for overall...

Got the skid plate and the rad guards/braces for my '07 EC300 from Scorpion. The bike tumbles over/under/through a lot at McNutt on my weekly rides and the guards do their job admirably. Fit & finish perfect - easy and solid install. I only had to pull the right wing back away from the water...

Here are a couple more courtesy Anthony Wunderlich on camera and poor sod on GasGas: Pictures taken at the start of the Main Jet hare scrambles in Merritt, BC on May 2nd 2010.

You can just bash them back to flat(ish) if they haven't been ground in half. I keep a couple around so I can swap them when needed. The one on the bike is wearing nicely while the one on the shelf has been retweaked a few times already! I have a kill switch I have just bought to reattach to the...

I went to scorpion after using the Hyde combo. Steve Vanderhelm was a fellow racer and knows the value of keeping the bike going through the worst of it! The hyde offered nice pipe and case protection but didn't save the frame rails from munching or from filling up with 40# of mud...

Thanks for these! I feel much more connected to the bike now. Pleasure doing business with you!

Well, I must apologize... after much trepidation and the buildup of butterflies in the stomach for this get together, my wingman and I bailed at the last minute. Friday night as we were talking about the last minute departure plans, I finally admitted that I was far from 100% from a good bout of...

They are a blast! And believe me, there is an end to the supply of adrenaline! Be sure to bring at least one woman along to prepare some food - an often overlooked and critical element for success! Besides, when she's not cooking, she can wash your bike! A bit of food could have saved a...

You didn't use Ian Mckill of Riders Edge Suspension in Vernon? Why not? I don't know the schedule of the Outlaw events (they're not on the PNWMA calendar) but the Merrit "Main Jet" is on Sunday the 2nd... If that doesn't appeal to the rest of the gang, we might do the ride the following...

Wow! You better get that thing dirty before it turns into a princess! Mind if we come up for a tour of your riding areas over the first weekend in May? We're looking for a destination for a spring trip...

Send them both over! I'm hard on my right footpegs (left one's two sets old and still intact...) PM sent!

Thanks for the clarification Roscoe! Though I'm sure with growling hunger at 7am, it wouldn't have taken us long to find it! We plan on leaving at 3am in order to meet you for breakfast. I posted up on our forum that I was attending this ride. Someone I ride with that you may know answered...

I'll be meeting you for breakfast in Belfair at 7am. My wingman Tuxedo Dave will be joining us on his Christini Pumpkin. This is Jimmy D's location: Here for pancakes! This is Elfendahl Pass Rd towards the staging area: Feel the butterflies! Any GPS tracks of the Tahuya trails to satisfy my...

You can't go wrong with this manufacturer: http://www.scorpionracing.ca/

I've got one sitting in a box in my shop with a partial wiring harness. It was removed by GasGasPacific and replaced by a racing harness. It is the head unit and the connecting wires but without the the handlebar switches, regulator, horn or any lights. It does, however, have the magnet and...