Recent content by nowheelies

Good News Everyone! I'm replacing my piston and rings and was wondering if i could get some commentary on the shape of my piston and rings? see below images, whaddya think?

TBH I don't know. I pulled the harness again and rechecked continuity, resistances, etc. On reassembly I got spark, I must not have had it connected properly or something was grounded that should have been. Really appreciate the help, Jeff

Don't sweat it too much! i got spark today so the wiring diagram is confirmed to work; kill switch blocks spark when it needs to, etc. in fact no wiring needs to go to the regulator to get spark. Thanks for the help! Jeff

I believe this meets the requirements for sparks: 1) Single exciter winding on the stator plus wires 2) Pulse trigger outside of the flywheel plus wires 3) CDI plus wires 4) Ignition coil plus wires 5) High tension lead plus spark plug 6) Grounds for the engine and coil etc. (Ref: Neil E's post...

Ok so I modified the electrical schematic using paint, this is what I have wired in on the bike. everything looks ok to me; one wire off the regulator but it normally goes to the key start. Can anyone see any issues? Note: the key start is removed, headlights/brakes switches removed, E-Start...

Neil, Just from the bike manual, see GasGas Website: http://www.gasgasmotos.es/en/manuals/download-manual_enduro_2012_e_en.pdf.html See page 17. Can zoom in pretty good Jeff

And just for fun the wiring harness:

Thanks for the help Neil, I dont have the key on this bike, the key switch has been removed. This complicates things a bit, but i think the solution is to jumper two wires somewhere, perhaps wire 38 as per wiring diagram can be grounded? (see wiring diagram 1) I confirmed numbers on...

Hello all, new user here and I have an issue. I searched the forum and was not able to find anything too fruitful, I bought a 2012 EC250 w/ electric start. When I bought it, it didn't run (had no spark) but after a couple days work I got it going. This time around pulling it out of storage I...