Recent content by Patswild300

Have used 927 for the last 11yrs. Love everything about it...

It will change your port timing....

Im at 5200 feet and here's my jetting on a Wild 300 35 pilot 1 turn out needle 2nd from the top #6 slide 168 main

Thanks Barkeater

Thanks Barkeater

I have the Wild HP300 where can I get aftermarket carbon fiber reeds or a reed valve?

Thanks Mike It had a #40 pilot and it was worse I think, Thats why I went with the #35 and went another half a turn out. I was going to up the main another size up and see..I also tried the needle in the middle and it had the hesitation so I went to the 2nd fron the top and it cleaned it up alot..

Great info.....The float was the first thing I set.. Where can I get the CCK needle? Do you think I should go to a #7 slider?

Well jetted it today . Dropped the pilot to a #35 1 turn on the air fuel screw, and put the needle in the 2nd to the top slot and upped the main to a 165. Also put in my new UNI filter and new plug. Bike ran great and better then its ever have since ive owned it. But thats only a few weeks...

Thanks for the info guys,

Ya a 5200 feet!

I have a Gas gas Wild 300 two stroke. I just bought the bike and the bottom end need some cleaning up and it loads up. I'm at 5200 feet. The carb is jetted Main 150 pilot 40 ...1/2 a turn out needle in the top position n1ef is the needle number slide is a #6 I have a #9 slide. What does the...

I would email PEP or SCOTT and see if they make one..

Thanks for the info.

Thanks..........