Recent content by patti larsson

  1. P

    airbox-reeds no longer in alignment. opinions/options please.

    Squeeze your reed valve boot looking for any cracks . If replacement is needed boyesen is the best place to buy, $ 7.00 If you have the hose clamps that are plated together get rid of them , and replace with two separate hose clamps .Install carb and reed boot, this is the most important...
  2. P

    Electrical Issues '03 EC200

    Bad Stator I think you have a bad stator .Here are the reading I took from my new "OEM GasGas Stator" Pulser coil gap 0.75mm Red-Green 100 ohms Red meter to green cable - black meter to red cable - remove spark plug kick hard 5 times should read 5 volts. + - 1 volt . Stator, Exciter Coil red...
  3. P

    Piston photos at 4,000 miles

    Thank you Hydro Dog and Jostby for not jumping to conclusion's. I think you hit it right on the head "sucking in coolant" I don't know why I though oil. I must be getting dumber in my old age.I seen this before with leaking head gasket on cars.I also worked on propane engines and was always...
  4. P

    Piston photos at 4,000 miles

    I am not a liar or a bragger ,believe what you want ,just stating a fact. Lance
  5. P

    Piston photos at 4,000 miles

    Thank you for moving the thread Yes this is the honest to God photos from my piston and head with 4000 miles on it.That is why I took the photos. I knew no one would believe me.pennzoil marine tc-w3 100% synthetic -biodegradable ashless oil.It is not recommended nor do I recomend it for your...
  6. P

    Piston photos at 4,000 miles

    These images are from my 4th rebuild on my Gas Gas 300. I reused original Base and Head O rings all four rebuilds. The Oil I used was full synthetic Penzoil TCW mixed 40 to 1. Could not beleive the Good results of the oil. I recently won $500 worth of Amsoil, I am hoping to have the same...
  7. P

    2K-3 test values?

    stator readings Tim .The readings are from a new oem 2k2 $380. dealer cost stator . 27ohms -18 vac . My original stator failed when I turned my bike off one day and had no spark . open stator reading. I went the cheap route and bought a moose stator, it had 12.6 ohms and 12.5 vac .It would...
  8. P

    really need help with my electrical

    pulser coil stator coil Pulser coil gap 0.75 mm red-green 100 ohms red meter to green cable-black meter to red cable -Remove spark plug kick hard 5 times should read 5 volts.+ -1 volt. Stator,Exciter coil red meter to black/red cable - black meter to red/white cable 27.0 ohms kick...
Back
Top