Recent content by pevs

Thanks should be good for my 300 06:)..i`m too tight to buy a new gasser one @ ?98

does a yz 250f fit straight on?

Not a bad idea Dave, you can always sell them on fleebay aswell if you have a large stock,and they fit cr 250 etc

nice find Dave!...just bought 2 for £7 the other day:(

It starts and runs ok, but dont know if this build up is normal :confused:

Anyone know what the minimum cylinder compression pressure in psi for an ec 300 is, going to measure it next week after looking into exhaust port there is small amount black/brown build up 10mm below bottom ring, is this normal? Thanks in advance!

Thanks!..my hands were freezing last year..getting prepared well in advance this year:D

Do I need to convert to dc on my ec300 to run heated grips, I know some grips say 12v dc only ?? Anyone else done this?

As a matter of interest, does anyone know how many are from UK. on this site?

Thats so sad..thoughts and prayers with you

I had same problem and was driving me mad! changed the seal etc. Then I noticed one day when the engine was running and I was routing the breather pipe from the right hand side of powervalve that a small amount of water vapour was coming out of the breather pipe, as I had previously routed the...

All the best...I`m sure it will be a success:)

Me to,@ 50:1,runs clean

I have used them once with no problem, couple of days for delivery. I get most Gas Gas bits from Dave at Biketech 01225765765 http://www.biketechuk.co.uk/ next day delivery and always got what I want in stock.

Do you have to re jet carb if switching from synthetic to castor based, manual says 2% if syn...or 2.5% if castor (petrol/oil mix)