Recent content by pobit

NOZ_#3 = N1E_#2.5 clip. The two needles are identical. The only differance is the clip grooves are cut .5 clip richer on the N1E_ needle. Dave

The springs are still for sale. Thanks, Dave

New price. $25.00 with free shipping anywhere in the lower 48 USA. Thanks, Dave

.42 fork springs for any EC200 with Marzocci forks. These came out of an 06 and do not have much time on them. The stock EC200 springs are .40 so these are the next step stiffer and are for riders 180-195 pounds. Price is $25.00 plus $10.00 shipping to anywhere in the lower 48 USA. Thanks, Dave

I think you will find the 38MM a better choice. Try the jetting I suggested. It will give a clean, strong power band with no hit from bottom to top. The 200 needs the bigger carb to get it to rev out. Dave

New take out Marzocci .42 fork springs from a 06 EC300 with a set of new fork seals. $30.00 for seals and springs plus $10.00 shipping. Filters are sold. Thanks, Dave

The CCK#3 is too lean for the 200. The 200 needs more fuel from mid to top. You can use a C taper needle but it will need to be run in the richer clip position #4. This richer clip position will cause the off idle to be too rich so a leaner straight diameter is needed to compensate. A good...

Go Fasters will sell you individual shims or they have a whole asortment kit they sell. Dave

As much as it hurts to hear it, a nice 07 300 this time of year will only bring $4000.00 at the very most. Dave

We raced yesterday's National in Duqette Minnesota and had a chance to test ride the 09 GasGas from Go Fasters. Sign up for the race opened at 3 PM Saturday so there wasn't any other riders at the test site when we arrived there at 3:30. This was nice because Mark from Go Fasters let us ride...

My comment wasn't a slam on GasGas. I like GasGas. We raced them for 2 years and had good results and I would race them again. But comments like "my friend who owned a 07 KTM rode my 02 GasGas with a flat tire and thought it handled better" was a little over the top in brand loyalty. Dave

I owned and raced 05 DE 200, 06 DE250 and a 06 DE300. I now have an 08 200XCW and a 08 300XCW-E. The new for 08 KTM frames are much better than the 07 down KTM's were. My KTM's out handle, out power and out stop my GasGases. The new PDS rear shock tracks straighter and is more controled than any...

Try a DDK or DCK needle. Same diameter with a richer end taper. Or use a leaner C needle in a higher clip position to richen up the end taper. CCL CCM #4. If you want to see when the main jet kicks in, remove the main jet and ride the bike. The motor will cut out from being overly rich at the...

Differant years came with differant springs. The older bikes came with 4.8-5.0 Most of the bigger 05 up bikes came with 5.2. Both springs are still for sale. Thanks, Dave

Priced to sell: New take out .40 fork springs for Marzocci forks. $20.00 for the pair ohlins rear shock spring 5.2 with 6 months use. $25.00 ohlins rear shock spring 5.4 with 6 months use. $25.00 2 twin air filters, almost new. $10.00 each new fork seals for Marzocci forks. $10.00 for the pair...