Recent content by poelinca

Nice job! The weekend is near, let us know how it runs.

Didn't Rod do demo rides in the US to show case the 2018 model ? That's what I remember anyways, they even did a couple of demo rides around here too (in Romania you can even rent these at major enduro events, one bike got stolen tough). My wish for '19 is for Lars Enoeckl on the podium for one...

What needle are you using ? Try a different premix oil, with a lower flash point (like a semi synthetic one). Use full synthetic only if you run the bike pinned most of the time. That should deal with the spooge/wet plug a little bit, but it will not fix the jetting issue. For...

My inlet rubber is roughly 33mm long (eyeballed it as i can't fit the calipers in without taking the carb or the tank off). I don't quite understand where should a take the second measurement, can you post a pick ?

They both do as far as I know, but Lars Enoeckl has more chances at catching a couple of podiums as he is well younger (and a very good rider too). David retired from the pro scene and I think he only rides for fun these days (while Lars Enoeckl is looking to join the pro scene). I suppose...

Is this what you are looking for ...

Cool, there is mtb shop right around the corner from where I live. I'll check there on monday. Thanks.

Alright, thanks. I'll change it next week after I find some to buy.

Getting ready for the first ride this year, and would like to change the clutch master cylinder fluid but I only have DOT5.1 witch I use for the breaks. Usually I go with the rule that you can put 5.1 if the cylinder is rated for 4. But on the AJP clutch cover all it's says is 'use mineral...

I have bought one for a honda from aliexpress for very cheap. It fits the shape and the nose is perfect but it's slightly shorter in length than original, even if you warm it up with an air gun and pull it hard it still misses 1-3 centimeters to properly staple it at the back (the sides are ok)...

Newer GG part# is BE620122508 witch replaces the older GG part# BE250022064 you are looking for. Maybe give that a try thru your dealer, it should be very cheap so no biggie if they don't interchange (even tough they are listed to interchange on motocrosscenter, which never failed me).

Taught so, I ended up placing the order from Spain. I'm not close enough to a shop that can machine the bushings. Thanks, Dorin

Are there any crossover bearings, bushings, seals and washers for the rear brake pedal ? Mine are broken, literally split a bearing apart, the seeger washer and bushings on that side can't be reused anymore. I'm looking at the whole "kit" so to speak, 32 thru 35 in the pic bellow I could...

GasGas 2018 line test ride: - location: Autocross Arena - Str.Ficusului nr.10, Mogosoaia - date: Sunday, October 22 at 11 AM - 3 PM GASGAS EC300 2018, TRIAL TXT, E-12, E-10, T-12

I personally know a guy who raced one of these at RedBull Romaniacs without issues (ended up 6'th Silver class) However the local kato dealer is already working to replace/fix a couple of these engines under warranty ...