Recent content by robicon

From what I understand there are two I would be happy with either at this point

Looking for the connecting rods that tie the system to the frame on a 2010 2t

looking for a head that would work on a 2010 2502t

I just had this issue I drilled out my only to find the new one was not correct. I did want to wait for a new one. I used stainless rivets and had to peen them for clearance. No problems

I would only be happy if they said it was totally redesigned new frame, engine, suspension, and more fluff.

where are you finding the 3s kit?

Looking for 300 head and cylinder to buy.

What about a house of horse power pipe?

$10 mailed to canada

do you still have the map switch?

nice thank you!

Any one have a map switch they don't use?

I may have one for you. I bought a core1 on here a couple years ago it was at the point of needing new friction plates on the ring when I got it, I was going to order new ones but they don't make them any more, I ran it for two years and it didn't change in that time still lots of adjustment. I...

bit of a high jack here! I replaced my basket with a s3 one this summer the rubbers were different but I didn't have time to look into it at the time. forgot about it until I read this. I e-mailed s3 and they wanted a picture does anyone have a picture of the stock ones?

I believe that nut is welded to the brace! remove the bolt from the other side.