Recent content by Rokondon

What does that lean slide modification do that RB has listed on his site?I like how the head mod looks

Try a Mikuni CDN,Im starting to think something is wrong in the design of the kehin.I think there are different slides available with a different cut around the air passage for the bottom of the slide?Or maybe the case induction gas gas design ports are to radical for a good idle?I dislike...

got it your right eff-I put in a 40 pilot and new reeds that seat flat and its much better.I had a 38 in it but it didnt want to run right-after i put in the 40 i was looking in the 38 and it had some crud stuck in it!Ran a mudsliging enduro in south jersey yesterday and it idled enough of the...

futile efforts on idle Yep,thats exactly the problem im still having.I changed the flywheel side crank seal(it was drooling but i dont think it was creating a air leak).Checked the boots to.I replaced the reeds with boysen carbon fiber pro,the old ones primary stage were not sealing-not laying...

Hmmm,after reading these replies i think i will pull the carb off and check it more closly,and look at the boots.I like that pressure tester-too pricey though id rather just change the stator side crank seal.The seal on the clutch side would pull oil in and it smoke a lot...right?I did have one...

hello new forum,01' ec250 .The old ongoing problem even with the LTR jets,Idles real high simmers down and peeders out since the bike was new.Another poster on the other site said to try a KDX needle.I have tried several pilot jets,the thing either screams or has some other quirky unstable...