Recent content by rvktm

my cdi shi@ it self can i use my o6 300 kosan or i have accesses to a new jd 015 017 cdi thanks

Anyone know if a Yamaha clutch basket Fits and what year thanks

any know the code or a good match

thinking of getting my 300 crank fb modified worth doing? theres a post from 011 best thing i did to my 300 .any one no the% to do it to thanks for any help

just got a well used 018 all the bearing are f@@@ . is the gg /rj kit any good my pan is to use orings to seal the bearings and 2rs needle rollers like all my old gg did .not happy the the hard bush /sleeve are only available as a kit ,the two in the l shape link 12 id 20 od iv found in my big...

my cunning plan just got a well used 018 needs rod crank bearings all the link bearings /swing arm . @@@@ surprise no e start workey my plan new rj cover my one worn out on the small hole . all the parts are ok ish going with them for now think the starter is a ktm ebay one .looking at all the...

on my 45s and venous vintage forks iv used steel shim to pack out the lower fork bush i get it of ebay

thanks pw 13 is the older spacing

had my 05 250 from new and just got my 98 ec back apart from plastics what parts are not out there gears ? sprocket shafts [my ones are not good] any help thanks

any suggestions on up dating the shimming on my 05 250 mostly woods use its just started leaking so its out of its second service in 15 years not bad amazingly the linkage is like new did the 05 to 011 linkage ratio change or get a better shock ttx ohlins ? fitting the sss fork soon only...

both my 05 and 98 ec splines are not good , any one managed to fit a bolt like ktm did the late gg have a bolt? will i get new shafts ? the suggestions so far on the 05 is to laser weld the 10 mm hole in the end of the shaft up and tap it ,screw cut a thread inside or out side ?. use a time...

did you look on ebay for a nitrogen needle . has it got wp 43 mm forks dont waste time money on them there not that good the 04 on 45mm oc marzocchi are very good woods fork or kyb sss

why bother gg pistons are made by most of the aftermarket company's

the best thing i ever did to get more grunt out of a gg 250 was a adjustable pv cover . didnt do much for the 300 i fitted it to. got a 4 ball 98 pv governor to try in my 05 .the works team had different springs .on ktm and beta the pv gov spring can be changed by undoing a bolt...

thanks mate supersized no one has a kit /alballs. Haynes has them for ?20 dont no if thats gen gg was thinking take a 1mm of it and a smaller seal got a nice old colchester student . was it you doing heads in the uk like to get my old 05 sorted.. must try the 98 4 ball pv governor