Recent content by Scotty97

Just taken my fuel tap out of my OEM tank to fit in my oversize tank, and noticed that the o-ring is squashed. Does anyone know what size is fitted??

Purchased this oversize tank off Gleiwitz (Damian) Was a bit worried at first, as tank was located in Poland, and I live in Uk. But couldn't fault the service. Communication was excellent. Item was exactly as described in description and photos. Shipping cost was supplied within 24 hours...

Is this still for sale??

Thanks I've just replied to the post to get a price

Hi I'm interested in buying this! Please could you send me a message with price for tank and delivery to UK. Scott

Does anyone know where I can get a new tank for my 2001 ec250?? Wouldn't mind a Clarke oversize one. I have tried the P-tex fix, and plastic soldered the holes up, but both start to fail after a few rides!! Its sunny in Wales, which doesn't happen often and I can't ride cos of my tank...

Does anyone know where I can get a new tank for my 2001 ec250?? Wouldn't mind a Clarke oversize one. I have tried the P-tex fix, and plastic soldered the holes up, but both start to fail after a few rides!! Its sunny in Wales, which doesn't happen often and I can't ride cos of my tank...

Well I managed to fill the two holes where the previous owner missed the inserts and screwed straight into tank. Not bad for first attempt at plastic welding using a soldering iron

Yeah, that's why I removed it, it was probably just the screw plugging the hole and the RTV being retained by screw.

I'm not sure either, never used it before. Maybe someone on here can tell us if it's fuel resistant. If not, may be I can make a plug to seal hole and then use P-tex or plastic weld to retain it. I think it's going to be trial and error until I find a solution

I'm not sure yet. I have ordered some plastic welding rods, and some p-tex. The previous owner had sealed it with another screw and black RTV. Any ideas???

Yes I removed the rubber gasket, but couldn't see s metal disk, it looked like a black plastic disk with a little hole in??? Il remove the inline filter and check cap again, but seemed very clean inside of the cap

I didn't measure it, but I'd estimate the holes where the inserts go are approx 7mm deep, but il measure tomorrow with a vernier. The thickness of the tank where they missed and screwed into tank is only approx 1.5 to 2mm thick

Well I just removed tank and somebody had botched the inserts. One was made out of piping, another out of a dust cap. And they also missed with two of the screws and pierced the tank!

Well took the cap and pipe off, and seems clear, what I did notice is that the end of breather pipe pushes on to a clip on the handle bars to stop it moving about. This was full of dirt so could have been blocking end of breather pipe. Does the breather pipe need a one way valve fitted...