Recent content by sheepy

Got it out. So simple why didn?t I think of it :o Just remove front forks slide of the axle and knock the shaft out the right hand side. Heated up the aluminium center bush and that just slid off. The bearing proved a bit more of a challenge tried to hit it off with a hammer no luck so had to...

Does anyone have the measurements for the axle OD of the smaller part where the end cap screws in and the OD where the axle puller is located cheers it?s a 2012 model as well cheers

I tied to remove my front wheel today to just do some general maintenance. Front wheel bearings. Tyre change Fork seals Well anyway when I went to remove the front axle it seems like the center bush has seized on to the axle I?ve tried knocking it out with a socket while pulling on the other...

The bike is totally different with this needle pleanty of grunt in the bottom end and nice to ride and then get on the pipe and wow front end up on ever straight going past loads of bike on the pipe in the hare and hound even had someone ask me what I had done to it to make a gasser sing like...

Well I got the n3ch needle today so it?s in the bike and what a difference haven?t rode it yet because of there being to many people around but just of the bench it sounds a lot different a lot smoother idle had to wind the idle screw back about 2 turns. Overall it sounds a lot cleaner. Im going...

So today I replaced the leaking float needle with one from a 2014 model it was 18mm long and old one 15mm thought this was odd as same carb maybe mine had One from an as1? But after a bit of bending I got the float hight to 10mm and while I had the carb apart dropped down to a 40 pilot jet...

Ordered a n3ch needle. Suzuki want ?19 for a nedj so going to ring round see if I can get it for a better price

I?m going to order them tomorrow and hopefully get them by Wednesday and will post up dates going to try both needles n3ch and nedj see how the different tapers behave and chose which one I perfer

Sorry my mistake it is a as2 it?s stamped al1 not as my mestake. So what jets do people run with the Suzuki needles neXX and n3xx needles ?

Definitely an as1 carb it?s printed on the right had side above the float bowl pwk as1 0 bf9 but the screws hold the top down meaning there is no threads in the cap on top

try adjusting the air screw might help to higher the idle

float height has been set to 10mm couldn't bring myself to go to 16mm can see how any fuel would get in if set that low. the float is about 10 degrees from parallel with the carb body. am i right in thinking that the NEDJ will give a more smoother power delivery as the N3CH will give you more...

ive just done a full engine rebuild and after a few rides thought it was running a bit lean it was overheating blowing out coolant and pinking. so i pulled out the carb as1 and found a 170 main jet, 40 pilot, n1ef needle on top clip, air screw 3 turns. so ive put it back to the standard 42...