Recent content by spooly

  1. spooly

    Retro fit e-start

    Looking for a parts list to what is needed to fit an electric start to a 06 ec 300?? Any info is much appreciated Sent from my SM-J610FN using Tapatalk
  2. spooly

    Needle experts please 300ec AS1

    Can u do a full post of the mod?? Sent from my SM-J610FN using Tapatalk
  3. spooly

    2001-2011 Large Used Parts Lot Gas Gas EC300 250 Etc.

    Deal of the century , pity I'm in a different country or I jump all over this .. I'll like to know who buys this job lot Sent from my SM-J610FN using Tapatalk
  4. spooly

    Rear offset footpegs

    What are them power pegs like? Can you post a pic?? Are they adjustable? ? Sent from my GT-I9300 using Tapatalk
  5. spooly

    7mm Allen tripple pinch bolts.

    I had the same problem..im missing one bolt.. and couldn't find anyone that stocked them.. Sent from my GT-I9300 using Tapatalk
  6. spooly

    Lowering the footpegs on the '15 chassis

    I could have wrote that post myself word for word the same story for me. . Im still not convinced that being back over the rear wheel a bit is a bad thing especially if your ust to trails riding... iv spent a full year riding with the pegs lowered and back and bars in the forward position with...
  7. spooly

    Low rpm torque improvement

    Soon enough I might be convinced! !! Are the connectors the same? Sent from my GT-I9300 using Tapatalk
  8. spooly

    cracked radiator / pipe?

    Make sure the bike is hot when checking for leaks.. so there's sufficient pressure built up in side the rad..id a pin hole leak before which caused boiling issues.. Sent from my GT-I9300 using Tapatalk
  9. spooly

    Base gasket 2011 EC300

    That's one for the books!! Was it just plug and go or did u change jetting etc Sent from my GT-I9300 using Tapatalk
  10. spooly

    Base gasket 2011 EC300

    Iv been through the hole base gasket debate and im still not happy..I started with .15 and worked up from that.. now im going to just level the exhaust port with piston BDC.. I did achieve more bottom and mid but it made it a pain to tune. . My two pence is if your a clubman rider like me level...
  11. spooly

    Help please! (Crank seals)

    Are both sides the same then? Sent from my GT-I9300 using Tapatalk
  12. spooly

    Help please! (Crank seals)

    (NJ206ETC3) ×2 Sent from my GT-I9300 using Tapatalk
  13. spooly

    Help please! (Crank seals)

    Iv actually ordered the wrong barings by the look of it..but I got one baring size off the parts list??? Sent from my GT-I9300 using Tapatalk
  14. spooly

    Help please! (Crank seals)

    Thanks very much Sent from my GT-I9300 using Tapatalk
  15. spooly

    Help please! (Crank seals)

    Phycho will u link me the thread? Sent from my GT-I9300 using Tapatalk
Back
Top