Recent content by tzsuzuki

Impeller arrived I received the impeller from check point two days after ordering it. Sadly my local GasGas dealer hasn't even followed up since I inquired about a stock one last Saturday. I should have checked the forum before installing it, Yikes! I guess I will open it up in the morning. I...

Fuses Munch, I had a similar problem that I chased for a year. I disconnected all the un necessary electrics, lights, key etc. problem seemed to go away. I recently re connected everything, problem returned. Turns out when I applied the front brake it shorted out 12 volts to ground and blew the...

Possibly...

Thanks for the info. I will,order one this morning

I just replaced the seal bearing and shaft on my 2015 xc 300. My impeller has a crack in it (which I may have caused during removal). At any rate I need a new impeller. With today Monday and the fourth Tuesday I won't even Be able to order one until Wednesday. Does the impeller cross over to a...

Selling my GG.lectron equipped. Gnarly pipe, HOH silencer, seat concepts seat cover, arc memlon levers, TMD skid plate, chain guide, and slider (new in bag). Squish corrected. About 100 hours on top end. Valved and sprung for 220 lb rider. Includes original parts manuals etc. clear title Located...

Come on down! One of my favorite races for sure. Round one is on September 18 at Cinder hills in Flagstaff. I rode there for the first time this past Saturday. Once again I am reminded as to how new I am to this. This place is made of cinders from a volcano similar but different to sand steep...

Pipe fit fine and definitely worth it!

Thanks SS

Doing my first top end on my 300. After 240 hours (that snuck up on me) power was a bit soft. For what it's worth the piston still looked really good and probably within spec. There was indication of lots of blow by though. My power valve was way over due for a good cleaning though, I believe it...

FMF lists a gnarly for 2014 but not 2015. I asked them and they said they haven't fit one up yet. Is there a difference between 2014 and 2015? Anyone tried one out on a 2015?

Yes plenty of rocks, but there are some interesting variations. The first round is in flagstaff at a OHV area called Cinder Hills. Course black sand from volcanic ativity. I believe it was where the lunur rover was tested.

Below is a link to the Arizona motorcycle riders association 2016-2017 schedule. http://www.amraracing.com/resources/2016-2017/2017_AMRA-POSTER.pdf A mix of enduro's and hare scrambles

Thanks for the replies. I bought it new last year. I would hope it's a matched set from the factory

Is there a way to determine which piston to order without opening motor? Is it marked on the cylinder?