Recent content by VORMAN

Do you have the clevis pins for the footpegs, and if so also what pegs do you have?

Ignition My bad, I meant to say I purchased the ignition after I replaced the black box. Must have been the red wine I had after feeling a little jilted from the price I had to pay. I got the Ignition today. I pray this works. The whole package comes with the pick up, mounting plate...

CDI Bad OK, after trying to isolate this electrical issue I have resorted to replacing the CDI after replacing the coil, Black Box, isolating the two speed ignition switch, fumbling with wires, checking grounds, etc. I ordered a CDI from Go Fasters. I checked their website and it shows $367...

Do you still have the new plastic for the bike? Thanks, JOhn

Still No Spark Well after trouble shooting the beast I replaced the black box. Low and behold still no spark. I am resorting to replace the coil and hope this works. If not it is off to buy a new ignition. $60 is better than $347.00. Getting frustrated :mad:

Thanks Glenn, My measurement came to 29.6 OHMS on the Black Red, Red White. I assuming it is good since I measured it at 85 degrees farenheit. That is what I was worried about. I will double check the other values. My gut feeling is it is OK and the problem leads to the black box. John

Does anyone have the Gas Gas specs for the 05 De 300 ignition? This edition has the MC model flywheel with an 8 pole stator, 9 wire. I need the specs on the stator, pulsar and pick up coil to determine if it is bad. I have no spark and the ignition coil is good. I need to narrow it down to the...