00 ec200 looking fresh!

[brenduro999]

here's a picture of my 00 ec200 looking like new! I rebuilt the engine, top and bottom.. fmf gnarly pipe, repacked the old silencer! linkage, swing arm, headstock and wheel bearings done! break pads F&R, 996 renthal bars and new grips, 05 plastics and a DRC seat cover (which is BADLY put on ) just waiting on a few more bits and pieces i have on order like hand guards, graphics etc..

 

[john r b]

look great, try putting the seat out in the sunlight(if any) to heat the cover
a little. then you may have better luck getting the wrinkles out.

 

[roverhybrids]

looks great!

 

[nknudsen]

Looks nice! Nothing wrong with that. Our old bikes can still get it done!

 

[Coop]

Nice bike! That wrinkled seat cover would drive nuts though.

 

[john01]

Looking good. Getting the wrinkles out of the seat is easy. Just pull out all the staples, start on the front and put in a couple staples in, next pull cover to the rear and put some pressure on the seat to slightly bow it in as you streach the cover over the rear, hold it there and put a few in the rear, then just work the sides. Good looking bike you have.

 

[Rick]

Several you tube clips on how to install a seat cover!

http://www.youtube.com/watch?v=ejvHEm_inJ4