07 EC200 clutch not working.

[justinholmes10]

so, i recently had my motor in the shop for a bottom end rebuild after swamping it. It had a new rod kit and bearings installed. i am now in the process of putting it all back together and today after refilling the clutch with mineral oil (i used baby oil) and purging it of all air, i am still unable to push the bike around while in gear whilst holding the clutch in. so i took the clutch cover back off and when i squeeze the clutch, i can see the pressure plate on the clutch extend. it seems like it may not be fully extending though. can anyone please help me out.

 

[pscook]

Very common, especially if you took the clutch apart and din't put it back exactly the same as it was. Read post #4 in this thread:
http://www.gasgasrider.org/forum/showthread.php?t=21527&highlight=dinner+plate

 

[justinholmes10]

I'm fairly certain that i put them back in the same way that i took them out, but i will try flipping them around tomorrow as that is the only way i could have botched it.

thank you for the reply.