2000 XC300 rear brake questions

[Adam500]

Restoring a beat up 2000 XC300.
It has an aftermarket aluminum rear caliper mount/disk guard made my Scotts.
I seem to be missing the thin steel hardware where the end of the brake pads sit/slide in.
Worse yet the aluminum has worn thru so the pads just spin on the pinned end when the brake is applied.
Where can I get a replacement caliper mount and hardware for caliper?
OEM is fine. does not need to be a disk guard combo.
Are there a parts interchange for Japanese bikes?
I have the ability to weld aluminum and might be able to save the Scotts mount but I need the steel hardware the brake pad sits in.

 

[(F5)]

So this happened to me, the steel clip fell out and the pads wore into the mount. This is an 07 so Nissin brakes.

I got it welded and filed back then put a new clip in it. The clip for a Nissin was the same as a *Honda CR250 and worth a few dollars. Not sure what brakes the 00 has.

 

[Adam500]

thanks for the response.
I successfully welded the caliper mount today.I Just need the steel hardware and a new set of pads.
What year CR250 did you use?

 

[(F5)]

Um. . . I just chose a year, probably 07. It looked the same in online parts fishe so I took in the part number, badabing etc.