exhaust Flange Gasket

[toadl]

Is there a parts crossover for the exhaust Flange Gasket for my 2003 EC250. I made one but there is not a lot of sealing surface area. I'm afraid it might blow out. Also I'm cheap so I want to include it in another order and not have to pay extra shipping cost from a Gas Gas dealer.

 

[motopsycho87]

Depends what you made it of and what the original is made of!

 

[toadl]

Depends what you made it of and what the original is made of!

I believe your correct, which is why I don't trust the one I made.

 

[bowhunter007]

I made one outta copper, for my old KX, as the old one was toast. Used a cardboard template, & cut it with air shears. The inside dimension I got with a hole saw...about 30 min. of careful hand filing got the correct diameter. The whole project took less than an hour.

 

[twowheels]

Is there a parts crossover for the exhaust Flange Gasket for my 2003 EC250. I made one but there is not a lot of sealing surface area. I'm afraid it might blow out. Also I'm cheap so I want to include it in another order and not have to pay extra shipping cost from a Gas Gas dealer.

Where are you located? We ship via the post office in an envelope for flat parts like gaskets ...

PM me.

 

[toadl]

Where are you located? We ship via the post office in an envelope for flat parts like gaskets ...

PM me.

I got lazy and ordered on from Hall's a couple hours ago.
I wish I would have read the post. They charged me $8 for shipping. I wasn't happy with that.